Do PETRO STAR MOUNT COMPANY IN CANADA EXIST? AND DO THEY HAVE SUB AGENTS

16 Answers  

---

• What do co-workers say about you

1 Answers   Petro Star Mount,

---

what is the use of choper motor in pyrometer ?

0 Answers  

---

Meil written exam papers

0 Answers   MEIL,

---

What is the difference between isotropic material and homogeneous material ?

0 Answers  

---

what are the parameters are selected while manufacturing a single cylinder block?what are the different kind of test is conducted on it so that it can withstand with all those condition which required to run the engine efficiently.which force is act when piston slide inside the cylinder.

0 Answers  

---

What are the principal constituents of brass?

0 Answers  

---

2. Dry saturated steam at 3.5 bar is expanded through a convergent nozzle to 2.2 bar. The exit area is 5 sq. cm. Calculate the exit velocity and mass flow rate, assuming isentropic expansion and super saturated flow. b) A cast iron cylinder head is fastened to a cylinder of 750mm bore with 12 stud bolts. The maximum pressure inside the cylinder is 3 Mpa. The stiffness of part is thrice the stiffness of the bolt. What should be the initial tightening load so that the point is leak proof at maximum pressure? Also choose a suitable bolt for the above application 2 The propeller shaft of a marine engine is to transmit 600 kW at 1200 rpm, without a significant bending. The efficiency of the propeller is 88% at 32 knots ( 1 knot = 1085 km/hr). If the slenderness ratio is less than 50 and the permissible shear stress should not exceed 65 Mpa. Determine the diameter of shaft. 3 A semi-elliptic leaf spring consists of two extra full-length leaves and six graduated length leaves, including the master leaf. Each leaf is 7.2 mm thick and 65 mm wide. The centre-to-centre distance between the two eyes is 1.3m. The leaves are pre-stressed in such a way that when the load is maximum, stress induced in all leaves are equal to 380 N/mm sq. Determine the maximum force that the spring can withstand

0 Answers  

---

the movement of piston is necessary for starting the engine na. then how does the big vehicles start. their piston can't be moved when the engine is at standstill. what actually the procedure........

5 Answers  

---

What minerals are used in the manufacture of cars?

0 Answers  

---

suppose if u selected ,when will u quit?

4 Answers  

---

what is the difference in Gas Welding and Gas Cutting?? Second Question is for Huge Casting which method is used??

0 Answers   Bhel,

---