how power factor improves by connecting syncronous motor

Answers were Sorted based on User's Feedback



how power factor improves by connecting syncronous motor..

Answer / pradhyumn

Synchronous motors draws leading current from the source,
while the inductive loads draws the lagging current. So
synchronous motor improves the P.F. by balancing the
reactive power needed by inductive load.

Is This Answer Correct ?    7 Yes 2 No

how power factor improves by connecting syncronous motor..

Answer / k.prakashchandra

It draws capacitive current from the system.

Is This Answer Correct ?    2 Yes 0 No

Post New Answer

More Electrical Engineering Interview Questions

THERMAL CAPACITANCE IS MEASURED IN..................................................

0 Answers   SSC,


can I connect 25KvA stepdown transformer(RYB-440V,UVW-240V) to the output of 15KvA,3-phase online UPS(440V phase to phase)please brief.

1 Answers  


Insulater disk using formula for 33/66/135 line h t line

1 Answers   Hofincons, Kirloskar, KPTCL,


HOW TO CALCULATE THE HEAT AND LOAD OF LT-SUBSTATION WHICH CONTAINS 2*1MVA TRANSFORMERS,LT SWITCH BOARD,MLDB,ACB,BUSBAR,ETC...?

0 Answers  


how to calculate the conductor size for certain KV transmission line and distribution line?

0 Answers   Hyundai,






hi friends ,iam working as genset AVR service engineer in electrical field from past 2 yrs throughout india . i plan to shift in some other job without travelling in same field because i con't travel,i dont know what i do for that so please guide me what job is suited for me,how i can serch the job please anybody helpme iam totally confused

4 Answers  


what is the formula for efficiency of francis turbine and generator for hydropower? what is best way to select francis turbine and generator?

0 Answers   HAL,


in alternator why on load terminal voltage is less than no load teprminal voltage

1 Answers  


What r the specification furnishid in motor name plate?

5 Answers  


what is the std. earthing resistance for 440V system or m/c, 33000/440 Volt substation? What is the std.?

2 Answers  


Why an ac systems are preferred over dc systems?

0 Answers  


What is the effect on in Zone and out zone fault if Phase side CT is Vk/2<30 mA and Neutral side is CT is Vk/4<30 mA for Transformer REF protection

0 Answers   ABB,


Categories
  • Civil Engineering Interview Questions Civil Engineering (5085)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4452)
  • Electrical Engineering Interview Questions Electrical Engineering (16636)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1095)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)