This is reqd for a 1MW Solar power plant..We have 2DC outputs from the solar p

This is reqd for a 1MW Solar power plant..We have 2DC
outputs from the solar panels Connected to 2INVERTOR
panels.. Output from invertor is 3ph,280v,500kva,50hz.These
are connected to individual ACB.This has to be stepped up
to 11KV ,1250KVA SYSTEM.Now can I use (1) one more ACBTO
GIVE A COMBINED OUTPUT OF 1000KVA,280V & STEP UP THE OUTPUT
BY USING a single two winding 3 ph transformer 11kv/1250kva.
or (2)use the two outputs and connect to one three winding
transformer of above rating..Pls suggestwith details.

Question Posted / n.balachandran

0 Answers
2439 Views
I also Faced
E-Mail Answers

No Answer is Posted For this Question
Be the First to Post Answer

Post New Answer

More Electrical Engineering Interview Questions

what is meant by insulation voltage in cables? explain it?

4 Answers ABB,

How do i carry out or know the vector group of a Dyn1 and Dyn5 transformer

0 Answers

Am using an electronic digital display to see the RPM of ABB ACS 550 drive, which is showing negative value when the motor & drive in stop mode but it is showing correct value during the run mode. can anyone help me out??

2 Answers Bala Power Solutions,

which of the following can produce maximum induced voltage..... (a)1amp dc current (b)50amp dc current (c) 1amp 60 cycle ac current (d)1amp 490 cycle ac current.

2 Answers

better choice of area of interest to post in our resume?

2 Answers Cognizant,

Pls any send the cable selection chart. at azeemk30@gmail.com

2 Answers

what are the reasons of CT circuit faulty in busbar protection scheme?

0 Answers Getco,

How to implement 6 output with 3 input NAND gate?

1 Answers

how do you select the ct/pt rating in substation

1 Answers Apollo, Shreem Electric Ltd, Tata Motors,

what happens when dc generator coupled with cycle shaft.also explain what happens when its loaded