Answer / hbeebur rahman

Wind pressure at any height above ground level shall be
obtained by following relation,Pz=0.6Vz^2.
where,
Pz=wind pressure
Vz=design wind speed
Vz=Vb*K1*K2*K3,
Where,
Vb=wind speed at particular place,
k1=risk co efficient
k2=terrain category
k3=topography factor
(for k1,k2,k3 values use is875 part3)

what could be the production cost of 1 cum of concrete by CP30 plant

0 Answers   GDC,

---

Why you are leaving present job?

0 Answers   HCL, L&T, NCC,

---

Required concret Surface Temperature prior to coating of epoxy pain with references ASTM or ACI whatever

0 Answers  

---

WHAT TYPE OF BINDING WIRE IS USED IN OFF SHORE STRUCTURES. WHEATHER COROSIVE OR NON COROSIVE LIKE EPOXY COATED,PLASTIC COATED ETC.

1 Answers  

---

Used Cement & Sand in 1 Square Meter or 1 Square Feet For Brick Work 0.115mm ? (1:4) (1:6)

0 Answers   L&T, Shoba Devlopers,

---

what will be hook length of stirrups

7 Answers   Rawabi Fayfa,

---

what is the minimum SBC of soil is required for different types of soil?

1 Answers  

---

Highest compressive strength of M15 concrete that can be gained at 28 days

3 Answers  

---

What is the purpose of the gap in the road on this bridge?

0 Answers  

---

what is the standard gradient or slope for drainage?

1 Answers   IGC, SPL,

---

what is preposition of M-5 grade

3 Answers   Montag Infrastructure,

---

silt%= silt volume/ silt+sand volume is this right?

0 Answers  

---