what should be the deduction for bend in stirrups while calculating cutting le

Categories >> Engineering >> Civil Engineering
Suggest New Category

what should be the deduction for bend in stirrups while
calculating cutting length? Is it 1 dia at each bend?

Question Posted / amolnagmal

6 Answers
11572 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

what should be the deduction for bend in stirrups while calculating cutting length? Is it 1 dia at..

Answer / ayush sharma

it is 2D for each bend

Is This Answer Correct ?

11 Yes

4 No

what should be the deduction for bend in stirrups while calculating cutting length? Is it 1 dia at..

Answer / sudhakar

for each bend it is 2d

Is This Answer Correct ?

8 Yes

2 No

what should be the deduction for bend in stirrups while calculating cutting length? Is it 1 dia at..

Answer / shah

+4d - 6d = -2d.

Is This Answer Correct ?

0 Yes

0 No

what should be the deduction for bend in stirrups while calculating cutting length? Is it 1 dia at..

Answer / ram

not above all answer
right but close to right=
2d to 2.5d

Is This Answer Correct ?

0 Yes

1 No

what should be the deduction for bend in stirrups while calculating cutting length? Is it 1 dia at..

Answer / jayavijayan k

There is no deduction for bends. We shall add the
additional bend lengthts on both sides.
For 30degree bend, the additional length at one side is 0.3D
For 45degree bend, the additional length at one side is 0.4D
and the hook length would be 18D for both sides.

Is This Answer Correct ?

0 Yes

4 No

what should be the deduction for bend in stirrups while calculating cutting length? Is it 1 dia at..

Answer / sameerkhan

There is no deductions of bends its a addition of 1d.

Is This Answer Correct ?

0 Yes

4 No

Post New Answer

More Civil Engineering Interview Questions

How do we calculate absolute pressure?

0 Answers

what are the types of dams

3 Answers

when does sedimentation occur before filteration, along with it, along with chlorination, after chlorination?

8 Answers NTPC,

how statics is different from dynamics

0 Answers

i have four storeyed rcc building.basement of the building is around 34 years old.it does not have pillar support.it is having lintel steel support at every 7 feet of construction. how long this building will lost long . can any body help me in this regard

0 Answers

What is the withdrawal force of steel nails?

0 Answers

whatis the banafit of water leak detection and repair?

2 Answers

What will be the angle for hook in column ring for column size 600x750 mm bar size 10mm for ring

3 Answers

How are freeway bridges built?

0 Answers

what are the compressive strength requirements(in 7 days & 28 days) of cement sand mix used for plastering purpose (Cement:sand-1:6)? Kindly give the IS Code reference also.

3 Answers L&T,

how to calculate cost of raw materials of a building for 1000 sqft & also consolidated cost of labour in a 1000 sqft building

0 Answers

How i calculate Cement sand Quantities in 100 Sq.ft Plaster?

1 Answers ABC,

For more Civil Engineering Interview Questions Click Here