Interested to Buy Any Domain ? << Click Here >> for more details...
how much current a 100 sq mm busbar will carry?
- 1 Answers
- 4704 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / mojinkoshy
It depends up on the material of the Busbar.
ie. if you use cu bus bar (SWITCH BOARD current RATING / 1.2)= CU. busbar area. if you use Al. bus bar (Switch board current rating/ 0.8) = Al. busbar area.
the bus bar area is normally expressed as 50X6 or 2Nos. 100X12 not like 100sq.mm.
| Is This Answer Correct ? | 4 Yes | 2 No |
Post New Answer View All Answers
A 3-phase IM is supplied from 50 Hz system. It runs at speed of 1440 rpm and slip equal to 4 %. Calculate number of pole pairs. A 1 B 6 C 2 D 3
What is servo motor? what is its purpose?
If a surge divertor is required to be protected by 32 amp C Curve Circuit breaker does this limit the amount of protection from surges that you will acheive
where rlc series ckt used?
is it possible to start a motor in felid connected to a remote mcc
1.What is the range of stator resistance of 3-phase induction motor? 2.Two electrically operated vibro motors are foxed in parallel direction in vibrating feeders. what is the direction of both vibro motors?
What is the rating of circuit breaker needed for 300 KVA load in 33 KV supply line in a transformer of 33 KV / 415 Volt ?
What is nyquist contour?
why actual valve timing diagram is different than ideal valve timing digram of a 4 stroke engine?
two way ckt diagram can be drawn by how many ways? give diagram
What are the material used for inductance coil?
why is the conservator tank painted white on the transformer
What will be the diameter of pipe between conservation tank and transformer
what is meant by motor startup supervision & motor load jam protection ?
What is the formula to find out two phase active & reactive power
