Answer / rahat

Backwashing

After the resins are exhausted, the bed is backwashed.
Backwashing is carried out by a uniform upward flow of water
through the resin bed. The backwash step expands the resin
bed releasing any entrapped particulate matter & removes the
channeling in the resin column if occurred during the
service cycle.

Answer / k. k.basha

softner bed is backwashed when the resins are exhausted,
resin bed releasing any entrapped mass & removes the
performed matter.

why do tangential entry require for a cyclone separator?

1 Answers  

---

Question 102 - (a) As an approximation, let v = Zc / 137 where v is the radial velocity for 1 s electron of an element, c is the speed of light, Z is the atomic number. For gold with Z = 79, find the radial velocity of its 1 s electron, in term of c and percentage of the speed of light. (b) As an approximation, let A x A = 1 - Z x Z / 18769 where A is the ratio of the relativistic and non-relativistic Bohr radius. Find the value of A.

1 Answers  

---

QUANTUM BIOLOGY - EXAMPLE 33.4 : (a) According to Landauer (1986), the capacity of human memory is approximately X bits. Assume that a human retains 2 bits / second of visual, verbal, tactile and musical memory, find the value of X if a human lifetime is approximately 2.5 billion seconds. (b) The total power consumption of the human brain is about 25 Watts. The bread of 100 grams will produce 1000 kilojoules of energy. How much bread is needed to run a human brain for 1 day?

1 Answers  

---

How can you estimate the efficiency of a pump?

0 Answers  

---

What is the procedure to estimate the friction factor involved in heat exchanger tubes?

0 Answers  

---

What is screen analysis?

0 Answers  

---

What are the some common problems associated with dilute phase pneumatic conveying?

0 Answers  

---

what is the symbol of sodiumj

2 Answers   HCL,

---

Explain how can you separate hydrogen peroxide into hydrogen and oxygen?

0 Answers  

---

what is mean by refinery

3 Answers   Reliance,

---

A cantilever beam of length L = 3 m carries a uniformly distributed load (UDL) of W = 20 N / m throughout the length. Calculate the bending moment, BM of the beam near the fixed end. What is the shear force, SF at this point? Let SF = -WL, BM = -LWL/2.

1 Answers  

---

What is a common failure mechanism for above ground atmospheric storage tanks?

0 Answers  

---