Answer / anonymous

the answer though quite npt predictable but we can assume it
to be as follows
since the middle road is of width 12m and adjoining is of
7.5 m each , so extra widening in middle road is not
required depending on the design velocity.
so the extra widening required will be in the other two
adjoining roads wgich may be taken as 0.5 m for both the
roads as width is already 7.5 m..

further depending on the ruling radius and design velocity
it may be summarized that no such extra widening is reqd.
where the deign velocity should be limited to 60 km/hr
depending on terrain

Difference between pre-tensioning and post-tensioning.

0 Answers  

---

1 + 1 + 1 + 1 + 1 + 1 + 1 + 1 + 1 + 1 - 1 + 1 + 1 + 1 + 1 + 1 + 1 x 0 = answer??? pzl tell the rite answer ??

23 Answers  

---

if dia of capillary tube is doubled the capillary rise will unaffected doubled halved none

1 Answers  

---

How to calculate woden area in sft and Cft

0 Answers  

---

cement constant for brick works

3 Answers  

---

which grade of cement mostly used in construction and why..??

6 Answers   L&T,

---

Coverage of 25mm.thick ratio of 1:4 cement mortar?

0 Answers   Sadbhav Group,

---

how can i calculate pcc and rcc cu.mtr rate? specify labor and material cost should be diff

2 Answers  

---

what is M20 ? 

3 Answers   L&T, Sukhwani Constructions,

---

what is c&c++?

0 Answers   IBM,

---

Why did you choose to be an civil engineering

16 Answers  

---

in a mix if desired concrete slump is not obtained , the adjustment of each concrete slump difference is made by adjusting water by which percentage

2 Answers  

---