Answer / anbarasan

we have to take multi type of input like proximity sensor
and encoder's and resolvers.
Basically use for resolver input. its discreate we
calculate exeact position using poscon controler.

what is phase to phase to phase to ground fault

1 Answers  

---

what is the calculation of power factor?

4 Answers   GATE,

---

Dear Respected sir how to test ABB REX521 protection relay by relay tester.

0 Answers  

---

If u take a kWh reading in 11 kV HT and 440 LV side at same time in yesterday today , then why LT consumed units 3-4℅ high as compared to HT units

1 Answers   Brigade,

---

A 6.6 KV/ 440V Xformer. what are the imporatant parts & equipment required for it's protection panel.

0 Answers   APTransco,

---

HOW VFD USED IN ENERGY SAVING

8 Answers   ITC Infotech,

---

Can we use Ccapacitive voltage transformer directly for metering purpose?

0 Answers  

---

# 4 hi friends i m from electrical branch and seeking for tech. + apti. both papers of hpcl plz get it available as soon as possible my email id is sumit_lig189@yahoo.co.in

0 Answers   HPCL,

---

why we use single core 630mm2 cable for transformer secondary side

0 Answers  

---

if the load is 80 amp for main fuse and 100 amp for breaker so how can we calculate the cable size (cooper ) .

0 Answers   Bhel,

---

Why we are not placing c.B 's btwn generator and transformer.? what happens when generator gets disconnected from transformer when it is running @ full load?

3 Answers   Areva,

---

what is the significance of 3.5 core cable? or what does this half core mean and why is it required?

5 Answers  

---