Answer / ajeet pratap singh(power palnt

Ratio test is performed in transformers, CT , PT to know the actual voltage ratio .
here we will explain about PT ratio test.

As we know that PT contain Primary winding (A1 _ A2) & its secondary is S1 & S2.

Now Connect A2 to earthing link.Take 220 V ac supply from external source.
Connect A1 to phase of 220v & connect earthing link to neutral of 220 v AC.
Now use multimeter in secondary side.If PT ratio is 132/110/1.732
Then in secondary side multimeter will read 0.196volt. If this value is not found then ratio test is not ok.& voltage ratio is improper.

which type of amplifiers are used in multimete?

0 Answers   NTPC,

---

what are the disadvantages in GIS over AIS

0 Answers   Tata Steel Limited,

---

how to calculate the size of cable for 100 kva load,?can somebody tell me with a formula

7 Answers   Havells,

---

what are the current specifications of bus ducts ? i ve seen in IPBD bth 22000 A and 1500 A in 400 kv switchyard . why it is so??

1 Answers  

---

why transformer rating in kva and motor rating in kw

11 Answers  

---

what happens if power factor is maintained at 0.9?give me the answer in technicall way rather than telling the penality n all

5 Answers   NCC,

---

HOW TO CALCULATE EARTHING SIZING?

0 Answers   L&T,

---

what are the effects when the frequency is decreased in any ac machine

1 Answers  

---

What is the deffirant between EARTH, GROUND AND NUTRAL

4 Answers  

---

Could the power factor on electrical system can affect the registration of the kwhr meter or the CT/PT? 

0 Answers  

---

CBCT selection

0 Answers  

---

I need to connect a synchronous generator to the grid using automatic synchronization and two circuit breakers (one for synchronization, one for end connection to the grid), how to determinate the required diameter of the cables?

0 Answers  

---