what power factor should we maintain to get maximum benefits
our organisation load is 10 MW?
is it best to maintain the PF at .96 rather than Unity to save
electricity bill?
Answer / michael
unity power factor is the best.. but it is impossible to
achieve a unity power factor in actual .
Is This Answer Correct ? | 0 Yes | 0 No |
if 6 earth pit value is 1.5 ohm then what should be the number of earth pit to make the value .8 ohm
What happen if we apply square wave or traiangular waveform voltage to the transformer primary winding instead of sinusoidal wave?
What is difference b/w fuse and breaker?
MCB Rating
In Power Line Communication (PLC) the wave trap is used to block communication signals from entering neighboring lines. My question is this: Why do they allow for different filtering arrangements on these wave traps? Isn't it always going to be a low pass filter since we want the power frequency to go through, and the comm signal blocked?
Why in celling fan stator are rotatig while rotor are steday
How to determine the breaking capacity such as break down current and break down voltage for VCB and CT's.
how to calculate capacitor rating for an induction transformer ex.for 12 mva furnace calculate capacitor rating
if flux and load static in dc motor and supply voltage increases 20% then what happened in speed
can a motor acts as a generator
How Calculat the Cable Sizing of HT/LT System & Explian by one Exampal?
is it possible to have dc motors on single chip