Answer / e.subash

Dear sir plz check your transformer OLTC Technical
specification and simply i tell difference

Transformer ratio = 3.3 KV/ 33 KV
Current = 785 A / 75A
if i provided OLTC in Low voltage side means

1) What is the OLTC size
2) Quanity of the material and Size of Contact points and
other things (Copper)
3)Transitent surges Compare When fault will happen

Answer / erarun

As per standard we have to maintain stable secondary voltage means load for uninterrupted power supply. To maintain secondary voltage constant we have to change the tap to higher value when supply (Primary) voltage is low.So this is first reason.

And second reason is that always LT winding put near to the core to provide lower insulation material rather than HT winding insulation.

Answer / abhishek goyal

Major factor is insulation of winding of transformer because
at the LV side it will nearer to the core or inside section
and HV is wound at the outer section of core or upper on LV
winding side. If we put tape changer at LV it is very
difficult to get there winding at outer portion (it will
effect on maintenance or manf point of view).

Other factor is if we change voltage at LV SIDE it should be
change very little as per requirement SO we will connect
tape changer at HV side for constant or stable voltage.

Answer / rajan

Onely HT side tape volage high current low copper size less BUT LV side current high voltage low copper size ingrese

An ISP is granted a block of addresses starting with 150.80.0.0/16. The ISP wants to distribute these blocks to 2600 customers as follows. a) 200 medium size businesses; each needs 16 addresses b) 400 small businesses; each needs 8 addresses c) 2000 households; each needs 4 addresses Design the subblocks and give the slash notation for each subblock. Find out how many addresses are still available after these allocations.

0 Answers   UOG,

---

I want to know the currect formula for industrial lighting lux caluculation & light fittings selection

2 Answers   MRF,

---

when we increase load , current drawn from source also increases why ?

5 Answers  

---

What is the difference between earth fault protection of motor feeder with CBCT and Without CBCT ?

0 Answers   Enmas, Michelin, Reliance,

---

LT, CC and LMU installed at both the outgoing circuits of 132 kv double ckt transmissio what its means ? and what are there use ?

1 Answers  

---

What is a transductor ?

2 Answers  

---

What are the difference between C-Curve and D-Curve for MCB's.

17 Answers   ABB, DLF, Essar, GK companies, Nissi Engineering Solution,

---

difference between cable and conductor?

6 Answers   TransOcean,

---

Why delta connected motors are used normally.

4 Answers  

---

A 10 kva ,400v/200V , single phase transformer with 10% leakage impedance draws a steady short -circuit line current of

1 Answers  

---

how many wires need to be bring to the motor if its star delta starter

5 Answers  

---

if installing the transformer why put the sprit the stone ?

1 Answers  

---