Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / abhishek goyal
Major factor is insulation of winding of transformer because
at the LV side it will nearer to the core or inside section
and HV is wound at the outer section of core or upper on LV
winding side. If we put tape changer at LV it is very
difficult to get there winding at outer portion (it will
effect on maintenance or manf point of view).
Other factor is if we change voltage at LV SIDE it should be
change very little as per requirement SO we will connect
tape changer at HV side for constant or stable voltage.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
whether fibre optic cable in high voltage earth conductor is used for protection circuits
what will happen if there is a voltage leakage or current leakage in an electrical train
what is difference between window type and wound type transformers?where we will use window type and wound type transformers?
WHat is the requirement of installing FAST ACTING EARTH SWITCH in GIS and how is that integrated with protection system. How and when does it operate?
How to design pavement quality concrete by using C.R.C.P Method
we have two motors 1250kW,6.6kV to be coupled on the same shaft ,so please provide assistance for their synchronisation.
how invertor convert the dc into ac give brif detail
What is primary and backup protection?
How to measure current and voltage in an ELV circuit
in a simple IDMT relay we use neutral point of ct for earth fault then what is the requirement of neutral ct and cbct?
sir, what is the importance of Fault MVA. how to calculate fault mva of 33kv substation connected by 6.5 km line(single circuit with equal spacing) with 110/11kv transformer in 110kv susbstation.the fault mva on 11 kv bus in 110kv susbstation is 208mva.
WHY THE DIMENSION OF TWO SAME RATED MACHINE IS DIFFERENT ?
what are different types of electrical windings? i know the distributed winding ,concentrated winding etc but i want some detailed information, in what condition we will use distributed,concentrated windings what are the difference between them which is best, how induced emf changes by using different types of windings 20 hours ago - 1 week left to answer
Why MCCB is Getting tripped sometimes when there is no load in the Midnight ?
write encoder 17 pins details? pin a;b+, pin b;w+,..pin s & t. what is the meaning of b+, w+? explain;
