why told ' x ' mer to transformer
Answer / k.prakashchandra
Trans also means ' to cross'.Strictly Tr should be denoted
as 'x former'.
Is This Answer Correct ? | 17 Yes | 6 No |
Can 4pole (3 phase+neautral )RCCB proper functioning in only 3 phase load (no neautral, no Earth) ?
What will happen if apply dc source for power transformer
why ct ,cvt should be stored in a vertical position?
WHY DOES NEUTRAL DO NOT CARRY EVEN THOUGH IT CARRIES RETURN CURRENT?
1.What is the maximum transmission voltage in india & where it is located? 2.more information about indian power scenario.
which motor have relatively high power factor and what is reason for have high pf? 1.capacitor run motor 2.shaded pole motor 3.capacitor start motor 4.split phase motor
What are dependent sources?
how to arrange the generator protection ansi 48 (loss of phase?)
WE HAVE A PROBLEM THAT THE MAIN DRIVE OF OUR CEMENT MILL HAS AN EARTHING PROBLEM?TWO OF STATOR WINDINGS INSULATION HAS BEEN COLLAPSED DUE TO AGING PROBLEM.THE PHASES HAVE BEEN BYPASSED AND NOW THE LOAD HAS BEEN INCREASED.WE CAN'T REPLACE THE MOTOR.KINDLY HELP ME BY GIVING SUGGESTION THAT HOW TO MAINTAIN THE STARTING TORQUE AND CURRENT FOR HIGH LOADS.
How much minimum insulation required between 11kv/3.3kv transformer windings?
What is the intent of short circuit studies?
In a parallel circuit dc circuit with two resistors, if you know the voltage, amperage, and one resistors ohms, what formula is used to find the second resistors ohms?