Answer / khalid

inter cooling purpose is to reduce the temperature of the
compress gas which reduce its volume, so the work done by
the comperessor will be less for less volume, which will
reduce the input power.
after the inter cooler there should be a seperetor to
prevent any liqude from entering the comperessor.

Answer / neeraj gupta

Inter cooler is provided after lp cylinder ,that reduces the temperature of the air delivered by lp cylinder at constant pressure so that the amount of work required to compress air in next(hp cylinder) stage is less ,hence the efficiency of compressor is increased.

Answer / n.k.singh

During compression the temperature of compressed air goes
up and this intercooler is provided to cool this compressed
air to safe value.Intercooler is nohing but a heat
exchanger which cools the compressed air so that it can be
compressed again and again depending on requirement.

Answer / shravan

The basic principle is that the steady flow compression or expansion is directly proportional to the specific volume of the fluid.Therefore, inter-cooling purpose is to reduce the temperature of compressed gas which inturn reduces the volume so work done will reduce.

Answer / azhar

Inter-coolers are provided between successive stages of a multi-stage compressor to remove the heat of compression hence reduces the work of compression (power requirements). The work of compression (power requirements) is reduced by reducing the specific volume through cooling the air. Thus inter-cooling affects the overall efficiency of the machine.

Answer / tanuja

In intercooler compressed gas from lp cylinder is to be cooled
by making compression less adiabatic & more isothermal,it will reduce the work of compression in hp cylinder.
Also due to intercooling temperature of gas decreases ,which
results in decrease in volume & increase in density of the gas.So ultimately volumetric effficiency increases.

Answer / shibin augustine matthew

Intercoolers are used to reduce the temperature of the incoming refrigerant from the previous compressor so that the volume of the previously compressed vapour refrigerant reduces and work requirement on the next compressor get reduced this result in less input power requirement. A separator is also used along with it to prevent the entry of any liquid refrigerant to next compressor.

Answer / ashok

intercooler is provided to reduce the temperature of
compressed gas from 180deg celcius. This is necessary for
next stage of compression

Answer / aditya

In short,intercooler reduces the temperature which is compressed by the low pressure compressor by keeping the pressure constant.

which mechanism is used to turn the vehicle?

3 Answers  

What is the pressure of fuel oil on main engine and diesel generator?

0 Answers   RRB, Trident,

type of welding

4 Answers   Samsung,

1)Why Bearing used in Motor and pumps. 2) Why Mechanical seal used in Pumps.

16 Answers   Biocon, Exxon Mobil,

What is the diffrence between four strock and two strock ic engine

14 Answers   Alkem Labs, Mechanical,

SOMEONE POST THE MODEL APTITUDE QUESTIONS FOR MRF TYRES PLz pLZ pLZ ..Very urgent

0 Answers   MRF,

CAN ANY ONE SEND ME THE RRB SECTION ENG. Q-PAPER .. MY MAIL ID :suresh25siva@yahoo.com, suresh.sivakumar@tcs.com

0 Answers   RRB,

what is the working principle of thrust pump in centrifugal chiller.

0 Answers   Blue Star,

What is the difference in specification of following pipe stand for 1 seamless pipe 200nb material SA355,P22,SCH80 AND 2 SEAMLESS PIPE 200NB,SA335,P11,SCH80

1 Answers  

The shear modulus of most materials with respect to modulus of elasticity is less than half why?

1 Answers   DRDO, RVNL,

how can a turbo charger work in systemic concept?

1 Answers  

why we use kg/cm2 in pressure gauge not kg/m2

3 Answers