Answer / k.prakashchandra

Yes.As the vector group was considered during
commissioning,the same will hold good.

What is NDR in HT capacitor panels.

2 Answers  

---

what is pmu

1 Answers   Alstom,

---

How RTCC panel is working and give single line diagram for RTCC with transformer?

0 Answers   AB Associates,

---

What is the rotor frequency of 10 Hp 1440 RPM 50HZ 415V ?

0 Answers  

---

Why Transistors are not used as switching devices?

15 Answers  

---

---

How you calculating the 30 Hp 3 phase AC motor of power what size of cable is used for this motor?

0 Answers   Dhanam Enterprises,

---

what is the advantage of Cathodic eathing system and what is the basic principle and how itis working, please explain clearly .

2 Answers   Meinhardt,

---

In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes

0 Answers  

---

How would you relate your key competencies to this position?

0 Answers  

---

the grid connection required for a 50 MegaWatt fotovoltaic powerplant is higher or lower than 35kv (high or medium tension)?

0 Answers  

---

In order that work may be done:(a) Two wires are necessary(b) The circuit must have a switch(c) Coal must be burnt(d) A supply of energy is required

1 Answers  

---

Why Closing coli supervision is not required for Circuit breaker.

1 Answers   JSW,

---