I have been using an 600VA with 0.6 p.f UPS with my desktop
which has 450W power supply unit.
Can anyone explain how can this happen . Because the output
of the UPS is 360W (600*0.6) (<450W)
No Answer is Posted For this Question
Be the First to Post Answer
What is the need for checking knee point voltage for CT's?
What is Phasing out test?
in 50 mw generator if field is open in full load running condition what happen and for protection which relay used?
Please tell me the earthing procedures adopted for the STAR-STAR 3 Phase transformer in india and give a better sugession for earthing
what is the difference between the voltage of 5 volts capacitor and and 5volts battery?
How much the fault level of 11 k.v.,22 k.v., 33 k.v. (in Maharashtra- M.S.E.D.C.L) for calculation of short circuit current & selection of h.t.cable.
what is the difference between star and delta connection?
what is cascade speed control device?and how this device control the speed of motors?
IS THERE ANY ELECTRONIC CIRCUIT TO REDUCE THE NEUTRAL TO EARTH VOLTAGE BELOW 3V ?
What is the difference between earthing & neutral.
what is the Knee point Voltage?
why +24 v and -48 v give to BTS? If -48v protect from surge then why we not use -24 v?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)