Answer / k.prakashchandra

capacity = AH x V watt hour

can you check the current and voltage of a 12 V battery by a digital multimeter in this fashion that apply the digital multimeter across the battery terminals directly ? say yes or no ... i sais yes ........... is this true or false ? plzz tell me and also explain ........ plzz thanks

4 Answers  

---

State angle criterion.

0 Answers  

---

I hv a question regarding power factor improvement just after transformer. I request you to reply me plzz. thank you sir. My friend has a small unit of fabrication. in his factory the main load is a welding machine, lathe machine, grinding machine. this load is not continuous type. now our electricity board has installed 16 KVA, 11000/433 V transformer for our factory. In the energy meter (trivector meter) at LV side of transformer, i hv seen power factor value of 0.15 only when only 3 KW load was flowing. Further electricity board has suggested to install 4 KVAR capacitor at LV side after energy meter. Now my question is that if we permanantly install and switch on 4 KVAR capacitor after energy meter, during some load on transformer and also without any load on transformer, wht will be the power factor shown in energy meter?i dont want to get any penalty by electricity board, so plz suggest me if i can permanantly install and switch on the 4 kvar capacitor or not at LV side of transformer just after energy meter? Thank you again and awaiting for ur positive reply soon.

9 Answers  

---

How the main bus bar rating of 400kV switchyard with one and half breaker scheme is calculated.

2 Answers  

---

What is the accepted limit to increase the choosen transformer capacity over the load and why ?

2 Answers   Asec,

---

What is difference between Electrical & Electronic Device? 

7 Answers   AZ Engineering, Vodafone,

---

Explain the Term in CT Name Plate – Class: 5P10

6 Answers   Jindal, SRES,

---

In a closed circuit if two 5volt power supplier are connected in parrel what is the current direction in tihs circuit?

1 Answers  

---

I have made a 3 phase thyristor full bridge rectifier. But at the moment it is working only for the half bridge operation. Both the half bridges are on operation separately but when i put it into full bridge operation the oscilloscope output is zero. I rechecked that the pulses are correct for each thyristor. what could be the possible reason for this?

0 Answers  

---

why phase to phase voltage is 400v while phase to neutral is 220v?

1 Answers  

---

how does a shunt reactor maintains the bus voltage???

0 Answers  

---

why power of fm is weaker than am?

1 Answers  

---