Pl. brief about break-down maintenance of machine tool.
No Answer is Posted For this Question
Be the First to Post Answer
what is the differnce between vector and phasor? are both same or there is difference between two term.?
what is the minimum distance between substation wall and LT panel outer surface?
WHY HUMMING SOUND OCCURED IN HT TRANSMMISSION LINES?
What is the technical difference between On delay timer and a Star delta timer?
What are the minimum acceptable insulation resistances of insulation of underground cable suitable for 0.440kV,11kV, 33kV and 66kV?
An engineer measures the direct current resistance of a transformer using ohm meter. When he/she takes out one of the leads of the meter, spark comes.. Why ?? This effect is known as...
what is smartµ grid technology?under coal gassification?
How one can check the MAIN of a house wiring ?
What is power factor why we should maintain the power factor unless what will happen
I have a relay contact rated at 220v dc which is supplied with a 24vdc from the panel,for it to trip the dampers(24vdc).What if the application of the relay changes so that it should work at its rated 220vdc then will it work at 24vdc supply given or any other consideration needs to be taken .....
How to check phase R,Y,B
what is the load amp of a 2 hp single phase motor?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)