in Contactor opearation Why there is a difference in the
values of the operate and release voltage in case AC supply
No Answer is Posted For this Question
Be the First to Post Answer
why onlyseries motors are used as universal motors? why not shunt?
i have 60Hz motor, can i run it at 50Hz power supply ???
difference between turns ratio and transformation ratio?
What is maximum load capacity of 800 VA inverter?
i want some interview related questions with their answers which can help for attend the interviews...
Is motor current is dependent on load.
if we give connection of 100watts bulb through a single phase energy meter ,the disc of a meter rotates why it happens?
HOW TO FIND OUT 1. LINE CURRENT, 2. PHASE CURRENT IN AN ALTERNATOR / TRANSFORMER WHICH IS FEEDING A I)STAR LOAD ii) DELTA LOAD, USING A CLAMP METER. NORMALLY WHEN WE USE CLAMP METER IN A DG SET THEN WHAT DO WE GET?? PHASE CURRENT OR LINE CURRENT.
What is difference between MCC,PMCC,PDB?
Which are resistive loads & which one are inductive loads : Refrigerator, Split air conditioner, ceiling fans, well pump, fluoresecent bulbs, T.V, CRT Monitors, Adsl Routers, C.P.U, Printers, Deep Freezers, Speakers, DVD Players, Microwave oven etc. ? Output Power for these Appliances Would be same like this : P = V * A * P.F Or would be changed ? thanks
Why two nos. un-tensioned wires are placed inside the PSC poles used by powergrid in RGGVY works.
Why the capacitor bank is keeping on for electricity supply and keeping it off for generator supply
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)