what is electronic regulator and how we can use that in
fans?
Answers were Sorted based on User's Feedback
Answer / deepak tyahi
Electronic regulator has the triac which is the
semiconductor device and bidircetional also. This mean that
current can flow in the both direction mean that it can
work under the ac supply also. this device have gate by
which we can control firing angle also mean that we can
control the r.m.s value of voltage. As we rotate the knob
of the regulator than this knob change the firing angle and
voltage. toque will be change and speed will be change.
Is This Answer Correct ? | 14 Yes | 0 No |
Answer / guest
electronic regulator is an electric device that send signal
to the fan
Is This Answer Correct ? | 0 Yes | 0 No |
Answer / ranjana
Electronic regulator is a group of resistance having
different value of resistances.For regulating the speed of
fan or to increase or decrease the speed of fan we can use
the electronic regulators and also they are more cheaper at
cost and reliable than other regulator.
Is This Answer Correct ? | 3 Yes | 6 No |
respected sir, sir recentely i have applied for chennai and tiruvananthapur section enggineer and juniour engg in electrical dept. but still i donot get how i have to syart my preparation and also t the same time i donot know exactly what they r going to give in the examinations i mean which sections they r going to give i donot know exactly, can u prefer whichh books i have to follow and model papers or both boards
WHY KVAR IMPORTANT WHEN ANY PLANT IS RUNNING ON IT'S OWN POWER PLANT?
In a star to star transformer can we use a common neutral for both star connected primary and secondary
what will happen when choke in tube light circuit was not working???
How a ship getting grounded
Why in Hv transmission line as we see there are generally 6 or more than 4 conductor wires are used instead of 4 i.e. 3 for phase and 1 for neutral wire?????
Tell me how you are ready to comply with the employment rules and regulations if your CV is considered for employment?
Normally the starter used to reduce the starting current.but the dol starter do not it,so why we use it?
i want wipro vlsi placement pattern please send me
what is the basis for selection of Protection CT class ? How anyone can decide whether to go for 5P10 or 5P20 ?
any body can give me idea or sketch of fuel(Diesel) level controller for genset.
why the active power flow of some line is increased when the active power of out is cut ?