Answer / anjan

ans; 650.

hint: both engines to do equal work.
so w1=w2
net work1= t1-t2
= 900-t2
net work2= t1-t2
= t2-400

900-t2=t2-400
1300=2t2
t2=650.

Answer / gattu18

a) 650

Answer / nizam

650

Answer / sailor

650
as
w1=w2
900-t2=t2-400
2t2=1300
t2=650

Answer / shajajan shaik

(T1-T2)/T1 = (T1-T2)/T1
(900-T2)/900 = (T2-400)/T2
T2900-T2 square = T2900-360000
Therefore T2 = 600K

Answer / manoj

600

What is the purpose of thrust bearing?

1 Answers  

explain the phenomena of autoignition in petrol engines

6 Answers  

What is the formula for converting Pipe Diameter to Plate?

5 Answers  

25 questions in 25 minutes were asked by L&T corein mechanical engg test on 28 nov 2011 are as follows:- L&t mechanical consists of 1> airfuel ratio 2> mollier chart for flow rate 3>homogeneous or hetreogeneous mixture 4>sublimation curve 5>effect on room temperature when fridge is opened 6>cop of refrigerator 7> punching and piercing uses shear or not 8>method not used for tapering 9>forming method not used for productn 10>numerical regardng no.of cuts 11>flow of chip is controlled by which parameters 12> property important for impact loading 13>stifness of spring when it is cut into 2 pieces 14> device reqd for energy fluctuation 15> property on which rivet is selected 16>crowning to prevent flat belt pulley errors like undercut 17>cavitation occurs at which stage 18>qstn regardng inventory control 19>for ship vessel industry what sort of plantlayout reqd 20>value engg definition 21> qstn on how the extnsn occurs for uniform loading 22> qstn regardng stress actng on the shaft23>maximum value of mohr's circle diameter 24>qstn regardng meshing of teeth 25>qstn on helical gear reqrd better read G.K.PUBLISHERS GATE PAPERS ESPECIALLY FROM 1993 to 2003 ESPECIALLY THEORY QUESTIONS RATHER THAN NUMERICAL QUESTIONS

0 Answers   L&T,

Is there a lower limit to the gland surface finish for static O-rings, gaseous system? surface finish table lists 0.41-0.81 micro-meters for static gaseous systems. What is the drawback of using a smoother surface finish lower than 0.41?

0 Answers  

Whe a system is said to be

2 Answers  

how piston moves from bdc to tdc during compression stroke. which force acted to compress the fuel at pressure....

2 Answers  

Explain why will an ice cube placed in a cup of hot rotating water spin automatically faster than the water itself?

0 Answers  

Identify the common problems and solution for gas turbines, diesel generator and wind turbine during operation.

0 Answers  

What is the materials of jib and cotter joints?

0 Answers  

Is there a simple method to measure the horsepower of a small motor (1-3 hp) for a non-technical person?

6 Answers   HPCL,

Is it possible to fix 1/2" BSPP Male thread with 1/2" BSPT female thread. If yes is it safe for gas transport applications.

1 Answers