Answer / vijay

4.5Tphsteam isrequired

Answer / g.janardhan

its depending upon boiler efficiancy,turbine
efficiancy,qulity of steem,
if there is no steam losses in boiler and turbine meens its
may be 4 to 4.5 TPH

Answer / a bhaskar rao

it depends on exhaust conditions of turbine & boiler steam
parameters as specific volume of steam varies with respect
to the steam pressure and temeprature, we can,t calculate
exactly.
For 100 % condensing turbine, the steam consumption may be
4.5 TPH with considering design efficiency calculations.For
back pressure turbine it depends on exhaust conditions. The
exhaust condition varies from factory to factory depends on
their process requirement.

Answer / rajesh

this will depend upon boiler steam quality and how much
back presuure is needed,roughly i can say that 5TPH
Required.

Answer / vinay

Can I have brief description of the above supported answers?
i.e On what basis you people calculated that 4.5TPH of steam required?

Answer / vivek kumar srivastava

aprox 3T/h

What is the difference between vertical and horizontal multistage centrifugal pump? which one has more advantages on the other?

3 Answers  

Why do we use solid shafts for transfer of power in case of pumps/ turbines & other machines why we use a hollow shaft (pipe) in universal joints of automobiles; although the rated load and twist is approx. the same?

9 Answers  

What type of job are you holding at the moment? What is your desired employment / occupational field

0 Answers   Radisson Blu,

Hi all, I am an Mechanical engineer, 2010 pass out, working as a HVAC design Engineer from past 2 years and I am getting pay of 2.5 lpa. I accidentally applied for SBI clerical post and I got selected, I am in a dilemma as to which to choose

2 Answers  

what is Retainer?

0 Answers  

Write down the epression for air standard efficiency of diesel cycle?

3 Answers  

hardness of grinding wheel is specified by

8 Answers   NTPC, TATA,

what is the relation between f and reynolds number?

5 Answers   Bhel, IGCAR,

why involute curve corve used in gear

5 Answers  

• What motivates you to do your best on the job?

2 Answers   Petro Star Mount,

How can conclude that whether it is gravity die casting component or pressure die casting or low pressure die casting and shell moulding?

1 Answers   Fenner, TVS,

what is the difference between run out and ovality

1 Answers