Answer / deepak

to transfer power from driving to driven shaft at low cost

Answer / jeeva

Transfer power from driver shaft to driven shaft

How can I masurement the diameter of steel ? like- 260mm dia x 12mm thick.

2 Answers  

---

how does thread of particular can be identified,how we can identify exact tap size for holes for example what is drill size for M6

3 Answers  

---

IF RPM OF PTO OF TRACTOR IS 540,torque at pto is 21kg/cm sq.& WE NEED IT TO 1800 RPM ,THROUGH GEAR ONLY FOR THAT WHAT WOULD BE ETHE GEAR STRUCTURE( I.E.NO TEETH OF BOTH GEAR ) IN ORDER TO GET 1800 RPM OUTPUT.

0 Answers   Eicher,

---

How to calculate motor bearing life - cycle (life time) (SKF bearing)

0 Answers  

---

What is the purpose of a turning gear?

3 Answers  

---

an engine operates between temp of 900k and t2 and another engine operates between t2 and 400k. for both engines to do equal work what shuld be the value of t2? a)650 b)600 c)625 d)700 e)750. with explaination.

6 Answers   General Motors GM,

---

What does SAE-40 represents? and what is a multi-grade oil?

1 Answers  

---

Hi! Greetings of the day. Can somebody tell me about as built duct sheet area calculation method. As we know that for this purpose A = (W+H)*2*L. But I have query about multiplication factors for elbows, tappers, offsets etc if there is any. Also refer the papers if available. Please revert. Thanks in advance.

0 Answers  

---

HOW WE CALCULATE THE WELDING IN JOB.

2 Answers  

---

What is non-destructive test and what is the purpose of it?

1 Answers   RRB,

---

What is the normal vacuum pressure in a steam turbine atmospheric condenser?

0 Answers  

---

What is the difference between isotropic material and homogeneous material ?

0 Answers  

---