Answer / bajrangi mishra

Spheroidising changes cementite from a lamella formation to
a formation based on an alpha ferrite matrix with particles
of spheroidal cementite (Fe3C)embedded. This resulting
steel has improved ductility and toughness compared to the
original steel with reduced hardness and strength.
This is done for ball bearings to avoid non-elastic
deformation of balls.

Answer / munendra kumar

it is done to reduce stress
concentration by making
spheroidised (round) grain
structure.because bearing are
subjected to the fatigue load
during its operation.stress
conc. is very dangerous in
fatigue load.

How to decide the thickness of sheet metal while designing the bracket?

0 Answers   TATA,

---

Q : How to calculate cooling water pumps head, do I need to consider static head and frictional loss of the pipe with high elevation? I mean to say is discharge pipe branches to several elevations and joins to the cooling water return line. The highest elevation pipe goes to a heat exchanger at (xx) psi inlet pressure. Should I consider only pump discharge header and this piping for head calculations? How about frictional losses in return pipe? Pressure recovered in return piping is good enough to make it back to the cooling tower?

1 Answers  

---

What is max pressure?

0 Answers   RRB,

---

Mention two types of dislocations.

0 Answers  

---

what is the thickness tolerances up to 32 mm

0 Answers  

---

what is the difference between shaft vibration and bearing vibration?

1 Answers  

---

Explain the advantages of gear drive?

0 Answers  

---

Please tell me about hydraulic machine.

7 Answers  

---

What is a positive displacement pump?

0 Answers  

---

what is the reasson after complition of suction stroke and started compression stroke inlet valve open for few digrees

4 Answers   TATA,

---

In a four-stroke diesel engine, In what engine exhaust valve will open?

0 Answers  

---

Why is nitrogen used in welding?

0 Answers  

---