Interested to Buy Any Domain ? << Click Here >> for more details...
Why spheroidising is done for ball in the bearings?
- 2 Answers
- 8116 Views
- Bhel, I also Faced
- E-Mail Answers
Answer Posted / bajrangi mishra
Spheroidising changes cementite from a lamella formation to
a formation based on an alpha ferrite matrix with particles
of spheroidal cementite (Fe3C)embedded. This resulting
steel has improved ductility and toughness compared to the
original steel with reduced hardness and strength.
This is done for ball bearings to avoid non-elastic
deformation of balls.
| Is This Answer Correct ? | 13 Yes | 0 No |
Post New Answer View All Answers
how to calculate cg of transformer
Where do you work in engineering company?
What is wrap-around?
What are the symptoms of broke piston ring?
What are the basis on which the best material for sliding contact bearings manufacturing?
In order to ensure constant pressure and constant flow rate of compressed air what should we put between the compressure and end user?
Give an example of a time when you had to explain some new procedures to your co-workers for quality service delivery. How did you go about it?
what is the calculation of selection ofan capacity is 12000m3/hr.
why the reaction turbines are not exposed to atmosphere? and why the impulse turbines are exposed to?
Steps In starting boilers.
Explain the difference between pearlite and cementile ?
What is higher IMP or BHR
What are the causes of failure of boiler tubes ?
Is copper tube withstand under hard water say as 500 TDS.And is it cleanable by solfamric acid or by tube brushing
In order to increase efficiency and reduce co emissions and other emissions, clear coal technologies are receiving major attention. What are these ?
