How an rtd work, and what volts/current goes to a rtd to measure the resistance?

0 Answers  

---

How to calibrate capillary type level transmitter

0 Answers  

---

What is DCS?

4 Answers   GAIL, Sabic, Trident, Yokogawa,

---

How can a d.p. Transmitter be calibrated?

0 Answers  

---

Why we are measuring 4-20ma? Why we are not taking 0-20ma? Plz answer this

1 Answers  

---

What is meant by GAP VOLTAGE, in vibration measurement. Normally how much GAP VOLTAGE is set and state the reason.

3 Answers   ADMA OPCO,

---

If range of 3-15 psi, a multiplying relay with a 1:2 ratio would give what output pressure for 6 psi input?

1 Answers  

---

i install a DP transmitter of Faugi on drum level of boiler but i face a problem in it when i engergize the transmitter the meter shows 0 or 100% no variation in it.the distance of two points is 19.5 inches, i am in trouble please suggest me what can i do it's very urgent Please reply me as soon as possible Best regards ikraam haider

5 Answers  

---

dear friends, i have seen flow as the selection critriea in presure guage (bourdon tube) and i would like to know what is the relation between flow and performance of pressure guage other parameters i found in the data sheet are pressure max. 1ksc temperature max. - 50 deg c line size - 80NB operating range - 1ksc pr. guage range - 0-2 ksc thank u,

0 Answers  

---

what is differance  between SOE an alarams

1 Answers   BMM,

---

The wire is disconnected from the fuel gauge sending unit (bimetallic gauge). A voltmeter connected to the wire reads a pulsating 5v. What does this indicate?

3 Answers  

---

SOME OF YOUR QUESTIONS ARE NOT MAKING ANY SENSE SO TRY AND PUT IN A LITTLE BIT MORE EFFORT BEFORE YOU POST A QUESTION. WE WILL ONLY HELP THOSE WHO WE CAN SEE ARE TRYING TO HELP THEMSELVES.

0 Answers  

---