What is Terminal Engine Meltdown?
Answer / hemender62
It’s the ‘irreparable’ damage to the internal moving parts
of an ICE, caused by overheating, either due its Lube OR
Cooling System failure.
| Is This Answer Correct ? | 21 Yes | 0 No |
Single reduction is used in final drive when it is about a) 6:1 b) 8:1 c) 10:1 d) 12:1
0 Answers Backbone, Bosch, MAHINDRA, Uniparts Group,
The permanent reduction provided by the final drive in car is a) 4:1 b) 6:1 c) 8:1 d) 10:1
0 Answers Backbone, Bosch, MAHINDRA, Uniparts Group,
The crown wheel of the final drive is connected to a) Cage b) Spider c) Cross pin d) Axle half shaft
0 Answers Backbone, Bosch, MAHINDRA, Uniparts Group,
What is back compressor in engines?
why we are using oil with petrol in two stroke engines but not in four stroke engines(two wheelers)?................
11 Answers Ford, GE, MAHINDRA,
Tell me the formula of heat loss in a pipe.
The land rover 110 defender stop because someone put water/kerosene in a fuel system,what can I do in order the to run again...
what is the role of electrical engineer in auto mobile industry,whether there is good future is there
What will you do if you are offered higher salary at a different organisation while you are working with us?
What are the points that must be kept in mind during forging design?
Can servomotor be used for applying torque or load to the gear box drive shaft at various speeds for gear box testing purpose.
What is the main task of batter in an automobile?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)