What is standard of DCS panel design?and what is step of DCS panel design?wiring and type of connector(screw or DB connector)

0 Answers  

---

If a transmitter is installed 10 m below its tapping point how much pressure exerted if fluid is water?

10 Answers   QAFCO,

---

how can i calibrate E & h make conductivity transmiter . unit : mocro siemens Range :0 to 100 micro siemens sensor : capacitive type

1 Answers  

---

What should we do when Fisher Fieldvue DVC2000 give some out put air at 4mA bt at that i need no out put

1 Answers  

---

Is wet leg type system nessesary to measure water level of steam DRUM? How the transmitter is calibrated to measure this level?

0 Answers  

---

Which standard is used for calibration of Control Valves ?

2 Answers  

---

What is the difference between PLC and DDC?

0 Answers   Emami,

---

diff c and c++

1 Answers  

---

Why we use DPT? can we use PT instead of DPT?

2 Answers  

---

i have one temperature TX in my loop check time once i was remove elament temp gose maximum then i am conect corectly but still now temp showing maximum what can i do this problem?

2 Answers  

---

define optical temperature detector

1 Answers  

---

typical loop drawing of a simple feedback control comprising of one transmitter and one control

0 Answers  

---