Answer / ashok prajapat

codensate pot is used before the pressure transmitters line
because temperature of steam is very high so this high temp. steam
directly may demage diaphagram of the pressure transmitter so we
use condensate pot and this condensate pot is filled by DM water
so steam temp not reach to diaphagram but diaphagram sense steam
pressure and hence it work acurately without demage.

Answer / shad ahmad

The main purpose of condensate pot is to catch and hold condensate and foreign material. This prevents damage to the metering system and/or manifold. The condensate may be drained from the bottom valve connection. OS&Y gate or ball valves to be used as the drain port.

Condensate chambers are used as a barrier between the main line and the secondary instruments in the measurement of steam or other vapors which condense to a liquid state insuring compatibility with the secondary instruments. They can also be used to cool down very high temperature liquids. Seal pots are installed where the line fluid is corrosive or viscous to the extent where it cannot be permitted to contact the secondary instrument. (transmitter or gauge) thereby acting as a liquid barrier between the line fluid and the condensate.

Answer / mr. rao

yes...., i aggrey with above answer, as well as steam
pressure flxevations also reducess.it meeans indirect
pressure will presented on diaframe, so transmitter out put
allso good.simple with help of condensate pot reducess
flexvationsas well as temperature effects up to serten
levels.

Answer / nitish nevgi

Hi guys!! I am not posting answer here, but please tell me why steam high temperature is not transferred to DM water or the condensate in condensate pot & tubing.

Answer / ushman

Hai.its ok
friends.pressure
transmitter site
its correct flow
transmitter site
why use condensate
pot with orifice
plate.plz tell me
its my mail
mohammedushman@gmail.com

Basically iam Instruemntation Engineer, but Iam interested in Instruments design engineering, so plz guide, is there any course, training or Softwres to become Instrument design engineer??.

0 Answers   Honeywell, Tata Steel Limited,

HI THIS IS NOOR AHMMAD.SHAIK, I AM WORKING IN INSTRUMENTATION MAINTENANCE Dept. in BOILER HOSE(BHEL HYDERABAD),,any other persons are working in same dept. i want some HELP in my subject

1 Answers  

Related to control system, What is difference between 4-20 mA active & 4-20 mA pasive signal.

1 Answers  

what is Best Among SINK Or SOURCE Type Design In Digital Signal, Either Iput Or Output? WHY?Can any one..

0 Answers   Accer, Reliance,

What is the calibration procedure of Drum level transmitter if range is 0 to -400 mmh2o in lab?

0 Answers  

WE Know that different supply voltage of solenoid valve like 24,110,220 etc..how we check the solenoid supply is 24v or 220 NOTE: No specification at device.

2 Answers   OMV,

which one is best profibus or RS485 for communication?

2 Answers   Honeywell,

when the instrument tapping on pipe line is located below and transmitter is located above the tapping point for liquid service transmitter, what should we do, is there any additional drain valve is required??

0 Answers  

how the flow rate is measured from a pipe with the help of pressure?

1 Answers  

How can I make calculation for Install level transmitter (DP) for open tank and cloes tank?

1 Answers   Petrofac,

Define cryogenic?

0 Answers  

I want to know if flowrate increases in 16' pipe line what will happen to upstream pressure and why?

1 Answers