in adaptor circuit there is a transformer(it has four input
& four output)which is used after rectifier .for what they
are using this? they connect input between 1&4 and get
output across 1&2 how it is possible?
Answer / jkm
possiblle. this is a tapped transformer. if you changing
pin 1 to 4 means output vltage will reduce. but in output
voltage will increase if you increase the pi configuration.
| Is This Answer Correct ? | 0 Yes | 0 No |
Why does a pure semiconductor behave like an insulator at absolute zero temperature?
What is the reason that sometimes we get network busy message in mobiles while attempting a call?
why current flow through conductor not insulator
what is resister
For 65hp motors how kvr capacitor should be on??
How many types of transformers are there? How does it works?
11 Answers ONGC, Shine Construction,
IN AN OSCILLOSCOPE TWO COUPLING IS THERE, THAT IS AC & DC COUPLING, WHERE DO WE USE THESE COUPLINGS ?
Why cannot we use leds for rectification purpose?
where do i get exercises for electronic circuits lab, i.e, designing various waveform(clipper, clamper, rectifiers)
difference between pre silicon debug and post silicon debug
WHAT IS VSE?
one year ago, promila was four times as old as her daughter sakshi. six years hence, promila's age will exceed her daughter's age by 9 years. the ratio of the present ages of promila and her daughter is
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)