in adaptor circuit there is a transformer(it has four input
& four output)which is used after rectifier .for what they
are using this? they connect input between 1&4 and get
output across 1&2 how it is possible?
- 1 Answers
- 2403 Views
- I also Faced
- E-Mail Answers
Answer Posted / jkm
possiblle. this is a tapped transformer. if you changing
pin 1 to 4 means output vltage will reduce. but in output
voltage will increase if you increase the pi configuration.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
interface an 8-pin switch with 8085 microprocessor located at 0AAH and LEDs at port 55H, draw the circuit diagram. Write down a program to read the switches and do the following: > if the parity of the switch is odd, start counting upward until it reaches 0FFH. > if the parity of the switch is even, start counting downwards until it reaches 00H.
A PLL maintains lock by comparing A The phase of two signals B The frequency of two signals C The amplitude of two signals D None of these
what is pla instruction
Explain shanon-hartley law.
Define what is intrinsic semiconductor ?
What is an astable multivibrator?
Define what do you mean by drift velocity and mobility of a free electron?
I am a fresher and i have done testing course from orbit institute hyd.can any1 say me whether it is necessary to do project in testing.if it is that which is best institute in hyd.can you please inform me if there is any job 4 freshers.thanxs
How can i display output voltage of my Power supply(DC) on the seven segment display ?? which IC is used?
What is a half-adder?
Define octet?
with a neat sketch, show all the interconnections required between a 8085 processor and a RAM of size 4KB mapped in the range 2000H-2FFFH.
Explain the operation of 3φ bridge inverter for 1800 degree mode of operation with aid of relevant phase and line voltage waveforms?
Can you help me correct FM transmitter circuit?
why the circuit turn off time should be greater than thyristor turn off time?
