How do you weld 25 mm thick plate?
Answers were Sorted based on User's Feedback
Answer / ayush garg
do butt welding and weld an insert plate on joints from
both side
Is This Answer Correct ? | 29 Yes | 7 No |
Answer / pankaj
we weld by butt joint & meet both plate's togatherand weld
on it from both side
Is This Answer Correct ? | 21 Yes | 1 No |
Answer / gaurav
Make "V" groove and then pre heating of the job is required
and proceed with welding. After welding RT is done and then
SR.
Is This Answer Correct ? | 2 Yes | 0 No |
Answer / trilok
Its welded by arc welding either fillet or butt type will
be suitable according to its orientation.
Is This Answer Correct ? | 2 Yes | 3 No |
Answer / raskalla
It depends. First of all, what kind of welding machine do
you have? Take care of the parameters (U,I,v).
Is This Answer Correct ? | 1 Yes | 2 No |
Answer / ankit jindal
for convinience point of view....mig will serve the best..
because continous supply of filler will be there for a 25mm
thick weld else simply arc welding with a suitable thick
electrode with proper v/i characteristics will also do the
job..pertaining to correct or proper electrode veiwing
technique.
Is This Answer Correct ? | 1 Yes | 2 No |
What will happen if there is moisture in refrigeration system
can i get interview pattern of bharath electronics limited ,
What is the maximum cylinder head temperature of a 1200 KW, 12 cylinders DG set
What is the indication of leaking starting valve of an engine?
What is the diffrence between head & total head in pump
what is shock in pipe line how it is happening
what is natural frequency & how to find it?
Discuss various surface finishing processes?
How do we calibrate the pressure transducer on the disharge line above our compressors? Or should it need calibrating?
9 balls are there one of them is of higher wt and remaining all are of same. given is one weighing scale and you can use it two times. How will you find the heavy ball in two trials only.
9 Answers Reliance, TCS, Whirlpool,
what is heat treatment and why is it done?
What would be the effect of surface roughness on the gas flow through convergent-divergent nozzle?