ple send to the how to improve the efficiency & economical
to the thermal power plant
Answer / k.prakashchandra
The efficiency is improved by employing economiser,air pre-
heater and better condenser
| Is This Answer Correct ? | 0 Yes | 1 No |
why ht motors are connected in star?
why permanent magnet generator have higher frequency of 400hz
what is the use of spherical metal balls attached on to the earth wire of transmission over head lines?
how to find the ballast lost from the actual wattage? for example i am going to buy decorative type 2x36watts fluorescent light fitting for this lamp how to find the ballast lost? is there any formula?
What Normal(Tangent) towers and Tension(Cut-point) Towers?
1 Answers ABB, BGR Energy, NTPC, Powermec,
How the field flux is controlled in DC drive ?
For Bus duct hi pot test, where we want to connect the return and ground leads?
how to calculate the cable size for 500 kva transformer?
What is the high tension lines voltage and low tension lines voltage?33 kv is high tension line or low tension.
What is real time power factor control panel(RTPFC)?
which one cable has a more resistance.A big or small
Why P.F(power factor)relay should not be connected to the D.G(diesel generator) incomer side
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)