The Network layer works with which of the following: A.) Globules B.) Bits C.) Packets D.) Segments E.) Frames

3 Answers  

---

GUYS i was refraining the OLD post and i got a good Question and wana make sure that you guys Just did not vist it for answers if you are not Aware google it understand it and then answered it the question is -: Significance of IP helper-address Command on SW? Is it necessary to put this command? you donot wana to give answer please donot visit this question and increase the vistor name if you are thinking that answer is wrong mark it wrong and explain why you are marking it wrong

0 Answers  

---

What are two purposes for segmenting a network with a bridge? (Choose two) A. to reduce collisions B. to increase collisions C. to add collision domains D. to reduce collision domains E. to have more broadcast domains

3 Answers   Ecobank, RNP,

---

Choose the following that are benefits to segmenting with router: A.) Flow Control B.) Manageability C.) Multiple Active Paths D.) Explicit packet lifetime control

1 Answers  

---

Which command displays the intenances using a given access list? A. show filters B. show ip interface C. show active lists D. show interface paramaters E. configure ip access lists F. show access-list interfaces

1 Answers  

---

What is fcs?

0 Answers  

---

Identify the following command to configure a secret password to 'cisco'? A.) Router(config)#enable password cisco secret B.) Router(config)#enable secret cisco C.) Router(config)#enable secret password cisco D.) Router(config)#set secret = cisco

1 Answers  

---

When you enter router passwords during the setup dialog what is the difference between enable and the enable secret passwords? A. The enable password is encrypted B. The enable secret password uses IPSec password authentication C. The enable secret password cannot be seen as clear text when viewing the configuration D. The enable secret password acts as a backup in case the enable password is compromised

8 Answers   Wipro,

---

When a Distance Vector routing protocol detects that a connected network has gone down, it sends out a special routing update packet, telling all directly connected routers that the distance to the dead network is infinity. This is an example of which routing technology? A.) ICMP. B.) Only Link State routing protocols have this intelligence. C.) Triggered updates. D.) Garrison-4. E.) Split Horizon. F.) Poison Reverse.

1 Answers  

---

Which IP Address Class is INCORRECTLY paired with its range of network numbers? A. Class A addresses include 192.0.0.0 through 223.255.255.0 B. Class A addresses include 1.0.0.0 through 126.0.0.0 C. Class B addresses include 128.0.0.0 through 191.255.0.0 D. Class C addresses include 192.0.0.0 through 223.255.255.0 E. Class D addresses include 224.0.0.0 through 239.255.255.0

4 Answers  

---

In regards to TCP/IP, which class of address allows for the fewest valid Internet hosts? A.) D B.) E C.) Classes are not used in TCP/IP. D.) B E.) C F.) A

1 Answers  

---

The following selections show the command prompt and the configuration of the IP network mask. Which two are correct? A. Router#term IP netmask-format { bitcount | decimal | hexadecimal } B. Router(config-if)#IP netmask-format { bitcount | decimal | hexadecimal } C. Router(config-if)#netmask-format { bitcount | decimal | hexadecimal } D. Router#ip netmask-format { bitcount | decimal | hexadecimal }

2 Answers  

---