What is the logical link control?

0 Answers  

---

Identify the command to display the Frame Relay map table? A.) Router# display frame-relay map B.) Router# show frame-relay map C.) Router(setup)# show frame-relay map D.) Router# show map frame-relay

1 Answers  

---

the situation iz like ths -at a specific time in our company the internet connectivity goes off...v hav two networks in our company...but out of it only one link goes down for 5-10 sec...a fastethernet port becomes down for few sec and automatically becomes Up... Is this occures becoz of Power?? If yes thn y the 2nd network is not affected??

2 Answers   SoftTech,

---

Identify the default IPX serial encapsulation? A.) Novell-Ether B.) SDLC C.) SNAP D.) HDLC

1 Answers  

---

Why mac address called physical address?

0 Answers  

---

---

Is it possible that in a switched network that any port of the switch can be infected with any kind of viruses that jamed and create more traffic in network which cause slow network performance?

8 Answers   HCL,

---

Which fields of an IP packet provide for fragmentation of datagrams to allow differing MTUs in the internet? A. Identification B. Flags C. Frag Offset D. Type of Service E. Total Length

1 Answers  

---

Identify 3 ways in which a router can be configured? A.) TFTP B.) Nvram C.) ROM D.) Console E.) Trace

2 Answers  

---

In STP the Root Bridge Sends the BPDU in Every 2 Sec,In BPDU What kind of Information is i.e. What kind of information BPDU Contains?

3 Answers  

---

What is true when creating static route? A.) The mask parameter is optional B.) The administrative distance is required C.) The gateway parameter is required D.) The administrative distance is optional

1 Answers  

---

Scenario: You created 2 access-lists for controlling telnet about a year ago, and bound one of them to Serial 0. You can't remember which access-list you used. Which command lets you see all access-lists on Serial 0 for telnet? A.) show access-list B.) show ip int s0 C.) show access-list telnet D.) show telnet access-list E.) show access-list s0 F.) show int s0

2 Answers  

---

Why we are not using subnet mask of class A in class C?before answering this question, just think upon if we do this then we don't need to move to IPv6.

2 Answers  

---