Answer / abhishek goyal

Its related to short circuit current because of that when we
design any plant and there electrical system. design
engg.(first calculate the total load)calculate the max SC
current according to that equipment will be select. Its
called the fault level:
it divided into 2 (Major):
low fault level (for normal equipment)
high fault level (for critical equipment)
as per total load of plant or capacity.

Answer / sakthivel

in our electrical system no of fault available there are
1,open circuits 2,short circuits 3,loose connections 4,earth
faults if any fault depends on voltage and full load current
and insulation cable so that is not idea,

1)What is a Triode? What are its uses? 2) What is a Triac? 3) What is a Thyristor?

0 Answers   Bosch,

---

WAHAT IS ELECTRICITY

5 Answers   Vijai Electricals,

---

what is the material use in bus bar & why.

3 Answers  

---

power transmission pole used one support , that only for support or earthing

0 Answers  

---

what could be the possible reasons for copper cable to have low insualation?

1 Answers  

---

What is the speed of electrical supply?

3 Answers  

---

Is it possible to measure the voltage of a battery from a single terminal?

0 Answers  

---

what is the difference between relay and a contactor.

5 Answers   Siemens,

---

how to select a breaker (MCB,MCCB,ELCB) for 18.5 kw, 3 ph. 480 v, 60 hz induction motor?

4 Answers  

---

How to check the LM324 Ic

0 Answers  

---

Define current?

14 Answers  

---

why field resistance is higher than armature resistance in dc machines? and why filed resistance is kept at min value at starting in same time of armature resistance at max value?

4 Answers  

---