Which device listed below provides clocking for the line? A.) DCE B.) CPE

Which device listed below provides clocking for the line?

A.) DCE

B.) CPE

C.) CO

D.) DTE

E.) Demarc

Question Posted / guest

2 Answers
6986 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

Which device listed below provides clocking for the line? A.) DCE B.) CPE C.) CO D.) DTE..

Answer / roopesh .k r

DCE

Is This Answer Correct ?

13 Yes

4 No

Which device listed below provides clocking for the line? A.) DCE B.) CPE C.) CO D.) DTE..

Answer / guest

Answer: C

Is This Answer Correct ?

4 Yes

10 No

Post New Answer

More CCNA Interview Questions

Explain isakmp ?

0 Answers CCIE,

Hi Friend. i have to let you know that now i have been selected for cisco india in bangalore. i am thanking to all of you guys that u have been posted such good question and the respective answer. from today i will be not able to visit this site on regular basic and hopeing that you will continue to post the question.the question you are posting is not very usefull to you but also usefull to another. i am again thanking to all of you and hope for best for your feature. Jitendera kumar sinha Network engineer-L2 cisco india Bangalore

0 Answers

What’s the default CDP holdtime in seconds for Cisco routers?

2 Answers

Which of the following is true regarding standard ISDN BRI service? A.) ISDN BRI B channels are typically 64K. B.) ISDN BRI can handle only voice. C.) ISDN BRI can handle only data. D.) ISDN BRI has 2B and 1D channels. E.) ISDN BRI D channels are 16K. F.) ISDN BRI can handle voice and data.

2 Answers

What is link aggregration?? How many types of protocol are used on that???

3 Answers Hathway,

What is the extended IPX access list range? A.) 901-1000 B.) 100-199 C.) 900-999 D.) 1000-1000

2 Answers

hi friends i have some problem regarding technical round ahr round plz tell me what should the right answer technical questions 1 what is brouter 2 what is the menaing of 10 base2, 10 base 5 and 10baset 3 what is diffrence between bit rate and baud rate. and this question was tooooooooooo much difficult to me that hr said to me that rank me after the taking the all short of interview

5 Answers

what is vlan

5 Answers

Write an access list line which will deny node 20.0.2.1 to anywhere on your network using DNS via UDP. Don't worry about the other access list lines.

2 Answers

Which command will show you if you have a DTE or DCE cable connected to an interface?

4 Answers DFSS,

what is the difference between a ‘half-duplex’ and a ‘full-duplex’ system?

0 Answers

Identify the 2 characteristics regarding MAC addresses? A.) Contains a network portion and host portion B.) Always assigned by System Administrator C.) 48 bits long D.) Contains a vendor code and serial number

2 Answers

For more CCNA Interview Questions Click Here