Answer / abdulkhalid.5

lmi(local management interface) frame relay technologies are
using lmi there are three type of lmi 1.lmi-type cisco
2.ansi ,3.q933a

Which of the following are examples of the Session Layer? A.) TCP B.) RPC C.) SQL D.) NFS E.) Token Ring

1 Answers  

---

Identify 3 methods used to prevent routing loops? A.) Split horizon B.) Holddown timers C.) Poison reverse D.) SPF algorithm E.) LSP's

2 Answers  

---

Identify the default values that make up IGRP's composite metric? A.) Bandwidth B.) Load C.) Reliability D.) MTU E.) Delay

1 Answers  

---

What is the best Difference between RIP, OSPF, EIGRP

7 Answers   Airtel, Gemini, HP,

---

Which peer authentication method and which ipsec mode is used to connect to the branch locations? (Choose two)

0 Answers  

---

Which of the following describe SMTP? A.) Used for downloading files to the router. B.) Used for sending e-mail. C.) Uses TCP. D.) Uses UDP. E.) Uses port 25. F.) Used for managing IP devices.

1 Answers  

---

Which command displays the intenances using a given access list? A. show filters B. show ip interface C. show active lists D. show interface paramaters E. configure ip access lists F. show access-list interfaces

1 Answers  

---

What are hold-downs used for? A.) To prevent regular update messages from reinstating a route that has come back up B.) Information received on an interface cannot be sent back out the same interface C.) To prevent regular update messages from reinstating a route that has gone down D.) To hold the routing table from being sent to another router

1 Answers  

---

What are the Timer of RIP, IGRP, EIGRP and OSPF Routing Protocol?

20 Answers   IBM,

---

Explain the draw back of ospf protocol?

0 Answers  

---

The Cisco Catalyst 5000 switch supports full duplex. How would you enable it on the second port of the card in slot 1? A.) router(config-if)# duplex full B.) router(config)# duplex full C.) router(config-if)# set port duplex D.) router(config)#port duplex = full E.) router(config-if)# set port 1/2 full

1 Answers  

---

Cisco routers use wildcard masking to identify how to check or ignore corresponding IP address bits. What does setting a wildcard mask bit to 0 cause the router to do? A. It tells the router to check the corresponding bit value. B. It tells the router to ignore the corresponding bit value. C. It tells the router to check its alternate routing list. D. It tells the router to use its primary routing list.

2 Answers  

---