The command 'debug ip rip' will do which of the following?

A.) Show Neighbor Info.

B.) Display RIP routing updates.

C.) Show routing table changes.

D.) Show all IP traffic.

E.) This is not a valid router command.

F.) Cause the router to respond with 'Ambiguous command'



The command 'debug ip rip' will do which of the following? A.) Show Neighbor Info. B..

Answer / guest

Answer: B

Is This Answer Correct ?    16 Yes 1 No

Post New Answer

More CCNA Interview Questions

After the command -- router igrp 200 -- what command would enable IGRP on the router for interface E0, with an address of 157.89.4.4 and a mask of 255.255.255.0 ? A.) network 157.89.4.0 255.255.255.1 B.) network 157.89.0.0 C.) router igrp * D.) router igrp 157.89.0.1 E.) router igrp int e1 F.) router igrp 157.89.4.1

2 Answers  


Can u convert an ethernet port to a serial port (or) vice versa ?

2 Answers   ADP,


Can anyone explain the STP Security features. Just like BPDU guard, Root Guard. Hi JITENDERA, i m specially looking for u?????

2 Answers  


Although Cisco IOS 11.2 and later can auto-detect the LMI type in Frame Relay, which command will force the LMI type to q933a? A.) frame-relay lmi-type q933a B.) encapsulation frame-relay q933a C.) don't need to, it is the default D.) encapsulation q933a E.) encapsulation frame-relay type=q933a

1 Answers  


What utility can you use to see the path a packet takes through an internetwork? A.) Route B.) SNMP C.) Trace D.) Ping

2 Answers  






What is the default encapsulation of Netware 3.12? A.) Ethernet_II B.) 802.5 C.) 802.2 D.) 802.3

1 Answers  


If you are running Token Ring with Novell IPX routing, which encapsulation should you use? A.) SAP B.) SNAP C.) 802.5 D.) 802.2

1 Answers  


What does CCNA stand for? A. Cisco Certified Network Administrator B. Cisco Certified Network Associate C. Certified Circuitry in Networking Apprentice D. Calico Cats of North America

4 Answers  


Which router command allows you to view the entire contents of all access lists? A. Router# show interface B. Router> show ip interface C. Router# show access-list D. Router> show all access-list

3 Answers   jetking,


Significance of IP helper-address Command on SW? Is it necessary to put this command?

1 Answers   Accenture,


What’s the easiest way to remotely configure a router?

0 Answers  


Which three devices can be used to convert the user data from the DTE into a form acceptable to the WAN service's facility? A. Modem B. CSU/DSU C. TA/NT1 D. CO E. SS7

1 Answers  


Categories