How do you disable CDP on the entire Router?

A.) Router#no cdp run

B.) Rotuer(config-if)# no cdp enable

C.) Router(config)# no cdp enable

D.) Router(config)# no cdp run



How do you disable CDP on the entire Router? A.) Router#no cdp run B.) Rotuer(config-if)# no c..

Answer / guest

Answer: D

Is This Answer Correct ?    3 Yes 0 No

Post New Answer

More CCNA Interview Questions

Extended IP access-lists (100-199) can be used to control traffic. Which command listed below will permit smtp mail to only host 3.4.5.6 ? A.) It is not possible for SMTP traffic B.) access-list 102 permit tcp any host 3.4.5.6 eq smtp C.) access-list 101 permit tcp any 3.4.5.6 0.0.0.0 eq 23 D.) access-list 102 permit tcp any any eq smtp E.) access-list 101 permit tcp any 3.4.5.6 0.0.0.0 eq 25

1 Answers  


Which layer is responsible for coordinating communication between systems? A.) Application B.) Network C.) Session D.) Transport E.) Physical F.) Data Link

2 Answers   HCL,


if i had a video conferencing device why should it is needed to configure a static IP for that,will it not work on the local lan.

2 Answers   HCL,


Assume that you are editing a line of text on a Cisco router. What key-stroke combination would take you to the beginning of the line? A.) CTRL-B B.) CTRL-Z C.) CTRL- D.) CTRL-A E.) CTRL- F.) CTRL-

2 Answers  


Identify 3 characteristics of an IP address? A.) Contains a network portion and a host portion B.) 32 bits long C.) Unique to each network D.) Part of the default Cisco configuration E.) Referred to as the hardware address

6 Answers   Infosys,






What device has content-addressable memory (CAM) and what is stored in it? 1 A: Switch, learned IP addresses 2 B: Router, learned IP addresses 3 C: Switch, learned MAC addresses 4 D: Router, learned MAC addresses

4 Answers  


Identify the 3 characteristics of IGRP? A.) Uses hop count as a metric B.) Supports multiple unequal paths C.) Administrative distance is 100 D.) Configured with an Autonomous system number E.) Link state

1 Answers  


Given the following IP address from the Class B address range 172.35.21.12. Your network plan requires no more than 126 hosts on a shored. Which value should you use as the subnet mask? A. 255.255.0.0 B. 255.255.128.0 C. 255.255.126.0 D. 255.255.255.128 E. 255.255.255.252

5 Answers  


What is the maximum hop count for Link-State protocols? A.) 15 B.) there is no hop count limit C.) 256 D.) 16

2 Answers  


What parameter is used with statically assigned routers to tell packets which interface to use to reach a distant network? A.) Mask B.) Subnet C.) Default gateway D.) Interface

1 Answers  


What is the routing metric used by IGRP? A.) MTU, delay, bandwidth, reliability, and loading B.) Count to infinity C.) TTL D.) Hop count

1 Answers  


Do you know how many types of data?

0 Answers  


Categories