Interested to Buy Any Domain ? << Click Here >> for more details...
How does a switch use store and forward?
A.) By using a Class I repeater in a collision domain
B.) The LAN switch copies the entire frame into its onboard
buffers and
then looks up the destination address in its forwarding, or
switching,
table and determines the outgoing interface
C.) By using broadcast addresses as source addresses
D.) The switch waits only for the header to be received
before it checks
the destination address and starts forwarding the packets
- 2 Answers
- 5656 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / aslam
B.) The LAN switch copies the entire frame into its onboard
buffers and
then looks up the destination address in its forwarding, or
switching,
table and determines the outgoing interface
| Is This Answer Correct ? | 1 Yes | 0 No |
What do you understand by redundancy?
Regarding frame relay, which of the following statements are true? A.) You must use ANSI encapsulation if connecting to non-Cisco equipment B.) You must use IETF encapsulation if connecting to non-Cisco equipment C.) You must use Q.933a encapsulation if connecting to non-Cisco equipment D.) You must use Cisco encapsulation if connecting to non-Cisco equipment
Which ISDN specification series deals with Concepts and Terminology? A.) World Series B.) I- Series C.) Q-Series D.) 911-Series E.) J-Series F.) F-Series
What is bia?
What type of Ethernet operation allows only one entity to transmit at a time? For example, if someone else is transmitting, they must wait. A.) Full-Duplex B.) Dual-Duplex C.) Half-Duplex D.) Latex E.) Quarter-Duplex F.) Suplex
Explain the term 'multicast'.
Identify the command to disable CDP on an interface? A.) Router(config-if)# no cdp enable B.) Router(config-if)# no cdp run C.) Router# no cdp enable D.) Router(config-if)# no cdp
Which two of the following protocols are used at the Transport layer? A.) ARP B.) UDP C.) ICMP D.) RARP E.) TCP F.) BootP
What is the syntax to use to configure the port on a Catalyst 5000 switch? A.) slot port/type B.) type slot/port C.) port slot/type D.) port type/slot
Identify the statement which connects access-list 101 inbound to interface e0? A.) Router(config-if)# ip access-group 101 in B.) Router(config-if)# ip access-group 101 C.) Router(config)# ip access-group 101 e0 in D.) Router(config)# ip access-group 101 e0 in
What are characteristics of UDP A. It is reliable and acknowledged B. It is unreliable and acknowledged C. It is reliable and unacknowledged D. It is unreliable and unacknowledged
what is the difference between dynamic NAT and NAT overload ? and how it works ?
CCNA 
