Explain what is 5-4-3 rule?

0 Answers  

---

How do you find valid hosts in a subnet?

0 Answers  

---

hi... i am usin packet tracer 5.0.. i hav connect two routers A and B. A has 200.100.25.100 and 1.0.0.1 and router B has 200.100.50.100 and 1.0.0.2... i hav connected 1.0.0.1 and 1.0.0.2... now i want to route 200.100.25.100 and 200.10.50.100 usin rip.. i enable rip in both the routers... but whn i give the command show ip route... i jus get this Codes: C - connected, S - static, I - IGRP, R - RIP, M - mobile, B - BGP D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2 E1 - OSPF external type 1, E2 - OSPF external type 2, E - EGP i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, ia - IS-IS inter area * - candidate default, U - per-user static route, o - ODR P - periodic downloaded static route Gateway of last resort is not set A# so can sombody tell me where i hav gone wrong... thanku

1 Answers  

---

You can access three forms of WAN services with Cisco routers. Select the three forms: A. Switched or relayed services B. Interface front end to IBM enterprise data center computers C. Using protocols that connect peer-to-peer devices like HDLC or PPP encapsulation. D. IPX/SPX E. NetBEUI

1 Answers  

---

As a system administrator, you need to provide your routers with a Domain Name System (DNS) server. How many DNS servers can you specify with one command? A. 6 B. 1 C. 2 D. 4

1 Answers  

---

Which of the following describe full-duplex transmission? A.) Uses a single wire B.) Data transmission in both directions, but only one way at a time C.) Uses a point-to-point connection from the transmitter of the transmitting station to the receiver of the receiving station D.) Data transmission in only one direction

2 Answers  

---

Which two of the following are valid ways to have multiple encapsulation types on a single interface? A.) This is not possible B.) subinterfaces C.) additional physical interfaces D.) secondary addresses

2 Answers  

---

Can you explain in a generic manner the packet of IPSec?

0 Answers   CCIE,

---

if i am using active directory,i have router also.then how i configure router,means which address will be default gatway in active directory & roter how to give ip address details in router.

1 Answers   IBM,

---

What is the distance limitation for 100BaseT? A. 305.955 ft B. 7283.46 inches C. 184 Meters D. 185 Kilometers

3 Answers  

---

Identify 3 UDP characteristics? A.) Reliable communication protocol B.) Applications that use UDP must incorporate reliability C.) Connnection-less oriented D.) Incorporates no handshaking

2 Answers  

---

What is the minimum and maximum request timer?

0 Answers  

---