Interested to Buy Any Domain ? << Click Here >> for more details...
Identify the purpose of the Ping command?
A.) Share routing information with a neighbor router
B.) Transmit user data when buffers are full
C.) Test connectivity at layer 3
D.) Test entire protocol stack
- 2 Answers
- 9800 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / monami85
answer : c
PING [ Packet internet group ].
It is unix based internet
diagnostic tool, consisting of message sent to test the
accesibility of a particular device on ip network.
the network user can ping another node on the network and
wait to see if it responds......
| Is This Answer Correct ? | 11 Yes | 0 No |
Answer / guest
Answer: C
The ping command tests layer 3 connectivity.
| Is This Answer Correct ? | 9 Yes | 2 No |
The ICMP (referred to in RFC 1700) is implented by all TCP/IP hosts. A. true B. false
How is rip different from igrp?
In stead of 0.0.0.0 wild card mask what you can write after ip?
Which way of communication bus topology use?
The Datalink layer works with which of the following: A.) Packets B.) Bits C.) Globules D.) Frames E.) Segments
On which base distance vector choose best path?
What 2 commands verify end to end communications? A.) Trace B.) debug ip session C.) Ping D.) Route
What are two purposes for segmenting a network with a bridge? (Choose two) A. to reduce collisions B. to increase collisions C. to add collision domains D. to reduce collision domains E. to have more broadcast domains
What is the function of DDR on Cisco routers? A. DDR is dial--on-demand routing. It provides a continuous LAN only connection. B. DDR is dial-on-demand routing. It provides routing for high volume traffic. C. DDR is dial--on-demand routing. It provides a continuous WAN connection. D. DDR is dial-on-demand routing. It provides routing for low volume and periodic traffic.
In IOS boot sequence if the flash is erased, and there is no access to TFTP server, and we can't load the partial IOS from ROM. Is there any possiblity that we can still boot the router/switch from external PC in which the IOS is installed?
Which command do you use to set the Privileged mode password to 'clearwater'? A.) set password=clearwater B.) enable privilege password clearwater C.) enable password clearwater D.) enable login clearwater E.) enable secret password clearwater F.) ebable clearwater
How does the cut-through switching technique work? A.) By using broadcast address as source addresses B.) The switch waits only for the header to be received before it checks the destination address and starts forwarding the packets C.) The LAN switch copies the entire frame into its onboard buffers and then looks up the destination address in its forwarding, or switching, table and determines the outgoing interface D.) By using a Class I repeater in a collision domain
CCNA 
