Answer / guest

Answer: B E

Answer / haja bahurudeen m

Ans : B,E


A - Layer3
D - Layer3
C - Layer3

Identify the 2 hardware components used to manage and/or configure a router? A.) Auxiliary port B.) ROM port C.) Management port D.) Console port

3 Answers  

---

What information can you get from CDP info: (choose all that apply) A.) Hardware platform B.) One address per protocol C.) Software platform D.) Hostname E.) The same info as show version F.) Incoming/outgoing port

1 Answers  

---

Which device works at the Network Layer of the OSI model? Router Switch Bridge Hub

5 Answers   CET, IBM,

---

Identify 3 characteristics of ISDN? A.) Transports voice and data B.) Transports voice only C.) Support both BRI and PRI D.) Runs over existing phone lines E.) Same as X.25

1 Answers  

---

What is the purpose of the DLCI? A.) Identifies the remote routers B.) Contained with a 802.2 frame for routing purposes C.) Used with PPP during authentication D.) Identifies the PVC in a Frame Relay network

1 Answers  

---

Which command loads a new version of the Cisco IOS into a router? A. copy flash ftp B. copy ftp flash C. copy flash ftp D. copy tftp flash

2 Answers  

---

Which port are used by Viruses? TCP or UDP?

8 Answers  

---

What is the default encapsulation and frame type on an Ethernet interface when enabling Novell? A.) SNAP B.) Ethernet_II C.) 802.2 D.) 802.3 E.) SAP F.) Novell-ether

2 Answers  

---

Can you explain the difference between trusted and untrusted networks?

2 Answers   CCIE, Wipro,

---

Which two statements about a bridge are true? (Choose two) A. A bridge floods multicasts B. A bridge floods broadcasts C. A bridge does not flood multicasts D. A bridge does not flood broadcasts

1 Answers  

---

CSMA/CD stand for which of the following? A.) Carrier Sense, Multiple Access with Collision Detection B.) Collision Sense, Multiple Access with Collision Detection C.) Collision Sense, Multiple Access with Carrier Detection D.) Carrier Sense, MAC address with Collision Detection

1 Answers  

---

What protocols can you use while testing Trace? A.) DECnet B.) CLNS C.) IP D.) Old Vines E.) Vines F.) Chaos

1 Answers  

---