1. Categories >> Certifications >> Cisco Certifications >> CCNA
  2. Suggest New Category

Ping uses which Internet layer protocol?

A.) RARP

B.) ICMP

C.) ARP

D.) FTP

Question Posted / guest

Answers were Sorted based on User's Feedback



Ping uses which Internet layer protocol? A.) RARP B.) ICMP C.) ARP D.) FTP..

Answer / guest

Answer: B

Is This Answer Correct ?    9 Yes 0 No

Ping uses which Internet layer protocol? A.) RARP B.) ICMP C.) ARP D.) FTP..

Answer / sharafu

Ofcourse "ICMP"

Is This Answer Correct ?    4 Yes 0 No

Ping uses which Internet layer protocol? A.) RARP B.) ICMP C.) ARP D.) FTP..

Answer / sandeep

Answer:- B.) ICMP

Is This Answer Correct ?    2 Yes 0 No

Post New Answer

More CCNA Interview Questions

Identify the true statement regarding subnetting? A.) Allows for more host address B.) Borrow bits from the network portion of the address C.) Allows for unlimited number of networks D.) Borrow bits from the host portion of the address

1 Answers  

What hppends when ping 127.0.0.1 command executes?

10 Answers   CMS, Wipro,

Identify the 2 commands that will display the status and information about interface E0 only? A.) show interface ethernet E0 B.) show interface E0 C.) show E0 D.) show int E0 E.) show interface

1 Answers  

Based upon the exhibit, create a static route to 172.16.10.0 on Router A A.) Router# ip route 172.16.10.0 255.255.255.0 10.1.0.2 B.) Router(config)# ip static route 172.16.10.0 255.255.255.0 10.1.0.2 C.) Router(config)# ip route 172.16.10.0 10.1.0.2 D.) Router(config)# ip route 172.16.10.0 255.255.255.0 10.1.0.2

1 Answers  

Which global configuration command will tell the router to load the IOS file 'IOS_filename' from FLASH memory at the next boot? A.) boot system flash B.) boot system flash IOS_filename C.) boot system IOS_filename flash D.) boot system tftp IOS_filename tftp_address E.) config-register 0x0102 IOS_ filename

2 Answers   HSBC,




What is true about frame-relay DLCI? A.) DLCI represents a single physical circuit B.) DLCI is optional in all frame-relay networks C.) DLCI identifies a logical connection between DTE devices D.) DLCI is used to tag the beginning of a frame with VLAN information

1 Answers  

Which of the following is a connectionless protocol at the Transport layer? A.) UDP B.) ARP C.) ICMP D.) RARP E.) IP F.) FTP

4 Answers  

In STP the Root Bridge Sends the BPDU in Every 2 Sec,In BPDU What kind of Information is i.e. What kind of information BPDU Contains?

3 Answers  

Identify the 2 rules used when configuring a Distance Vector routing protocol? A.) Physically connected network(s) B.) Configure the classfull address, no subnets C.) Enable CDP so neighbors can be detected D.) Same autonomous network

1 Answers  

Which of the following is True regarding passwords on a Cisco router? A. All passwords can be encrypted B. All passwords can be entered using the set-up dialogue C. A password can be set before a user can enter the privileged mode D. A password can be set for individual lines E. TACACS or Radius password authentication can be used.

1 Answers   TATA,

What is the mau?

0 Answers  

Identify the following command to configure a secret password to 'cisco'? A.) Router(config)#enable password cisco secret B.) Router(config)#enable secret cisco C.) Router(config)#enable secret password cisco D.) Router(config)#set secret = cisco

1 Answers  

For more CCNA Interview Questions Click Here
Categories