Interested to Buy Any Domain ? << Click Here >> for more details...
Why we are not using capacitor in line when load on Genset?
- 3 Answers
- 7868 Views
- I also Faced
- E-Mail Answers
Answer Posted / william lobo
By putting capacitor on Genset what we are doing is only
loading the genset additionally.
Capacitor is used to improve the power factor of the
system. This is important for the power supply cos; hence
they insist that pf should be 0.9 or thereabout.
Hence it is compulsory to use Capacitors to improve the PF
if below 0.8 or they will fine you.
When using a gen set we have to see what is the type of
load. If it is motor load inductive then we have to switch
on some of the capacitor banks only.
| Is This Answer Correct ? | 3 Yes | 4 No |
Post New Answer View All Answers
sir i had plane to do some project with the base of hopkinson test in AC supply its possible
I have doubt that the supply HZ (very low or high than rated ) may affect the power factor. is it true. ?
What is the reason behind current flow(20 A) in amain earth cable of an SMDB? Is cuurent flow(45A etc) through a neutral cable acceptable?
Differnce between negative Pahse SequenceFunction and unbalance Function?
What will happen if we introduce negative feedback to a control system that uses a positive feedback?
Explain few advantages of electric traction system?
Can anyone explain me about the capacitor calculation
What are the protection required for Transformer, motor, Line, Generator, capacitor, that all i have to refer which standard?(Like Transformer detail IS 2026)
What is an iron loss or core loss pi?
Which level of the Transformer oil got dielectric strengh? And why?
what happen as when voltage drop(or may decrease) ? in case of atomic base theory?
A 7 storey building has a floor area of 35,000sq.ft on each storey. On the ground floor 11KV electrical sub-station is to be erected. A load of 3kw for every 400sq.ft (p.f is 0.8) is proposed for each floor. fire pump 7.5hp, water pump 5hp, lift 2 nos, each 10hp and 20shop load of each shop is 5kw. calculate a. load each floor b. total load of building c. L.T feeders for aech floor and from transformer to main. d. distribution diagram e. capacity of sub-station/capacitor bank f. line diagram
What is the difference between PS & metering CT (5p20,0.5 etc.)? Why in PS class CT only Vk is given ? Is PS class CT is more accurate than metering CT?
What is the high series capacitance winding on high voltage power transformer ?
What is the armature mmf in a D.C machine?
