Answer / guest

Answer: C

what is difference between packet switching and circuit swtching

0 Answers   ASD Lab,

---

What is the administrative distance for RIP? A.) 100 B.) 90 C.) 120 D.) 110

3 Answers  

---

Identify the command to disable CDP on an interface? A.) Router(config-if)# no cdp enable B.) Router(config-if)# no cdp run C.) Router# no cdp enable D.) Router(config-if)# no cdp

1 Answers  

---

Identify 2 reasons for disabling CDP? A.) If the router is not configured for RIP B.) Save bandwidth by eliminating overhead C.) If the router is configured for Appletalk D.) When connected to a non-Cisco router

1 Answers  

---

Which command allows a user to see previous commands? A.) show command B.) CTRL-P C.) show history D.) CTRL-U E.) Up Arrow F.) SHIFT-CTRL-6

1 Answers  

---

Inverse ARP serves what purpose? A.) Method for a local router to introduce itself to the remote end of the connection B.) Broadcast a routing table update C.) Identify MAC addresses if the IP address is known D.) Sent every 10 seconds used to verify the Frame Switch is still active

1 Answers  

---

Which of the following is used to manage and monitor the network? A.) SNMP B.) HTTP C.) IP D.) FTP

1 Answers  

---

Why we used Virtual MAC in GLBP

0 Answers   Infosys,

---

mention the funtions about connection oriented and connectionless protocol and how it works ?

7 Answers  

---

Which layer is responsible for flow control, acknowledgement, and windowing? A.) Transport B.) Network C.) Application D.) Session E.) Physical F.) Data Link

2 Answers  

---

What parameter is used with statically assigned routers to tell packets which interface to use to reach a distant network? A.) Mask B.) Subnet C.) Default gateway D.) Interface

1 Answers  

---

what is the difference b/w pap and chap,and give comand to configure pap cahp on two router r1 and r2,

1 Answers  

---