1. Categories >> Certifications >> Cisco Certifications >> CCNA
  2. Suggest New Category

What is the Network Layer of the OSI responsible for?

A.) Bridging

B.) Routing packets through an internetwork

C.) Regenerating the digital signal

D.) Gateway services

Question Posted / guest

Answers were Sorted based on User's Feedback



What is the Network Layer of the OSI responsible for? A.) Bridging B.) Routing packets through..

Answer / guest

Answer: B

Is This Answer Correct ?    2 Yes 0 No

What is the Network Layer of the OSI responsible for? A.) Bridging B.) Routing packets through..

Answer / yogesh bhardwaj

B.) routing packets through an internetwork

Is This Answer Correct ?    2 Yes 0 No

What is the Network Layer of the OSI responsible for? A.) Bridging B.) Routing packets through..

Answer / rajendra kandpal

A

Is This Answer Correct ?    1 Yes 0 No

Post New Answer

More CCNA Interview Questions

An optional parameter on an IPX access is the 'LOG' parameter. This records access-list violations when a packet matches. What else does the 'LOG' option do? A.) Records the number of times that a packet matches the list. B.) Return a message to user who is denied access the by list. C.) Notifies an SNMP Agent. D.) Saves the log to NVRAM. E.) Send an SNMP Trap.

1 Answers  

You are given the IP address of 172.16.2.160 with a subnet mask of 255.255.0.0. What is the network address in binary? A. 10101100 00010000 B. 00000010 10100000 C. 10101100 00000000 D. 11100000 11110000

2 Answers  

Hi Jitendera, I continuously read your answers which is more knowlegable than books... Q.I am facing some problems in subnetting.can you plzz explain the subnetting process.. will be remain thankful

4 Answers  

Identify the 2 types of access-list filters that control SAP traffic? A.) Novell-ether B.) Arpa C.) Input-sap-filter D.) Round-robin E.) Output-sap-filter

1 Answers  

Can you explain PPTP (Point-to-Point Tunneling Protocol)?

1 Answers   CCIE,




What are the steps of conversion for data encapsulation?

0 Answers  

What type of frame does CDP use to gather information about it's neighbors? A.) TCP/IP B.) Novell-ether C.) Subnetwork Access Protocol (SNAP) D.) Ethernet_II

1 Answers  

Your network is having IP problems connecting to one or more Frame Relay peer routers. Which two commmands should you use to show the routers that are reachable? (Choose two) A. show ip map B. show ip router C. show frame-relay map D. debug frame-relay map

1 Answers  

The Network layer works with which of the following: A.) Globules B.) Bits C.) Packets D.) Segments E.) Frames

3 Answers  

What are the different types of password used in securing a cisco router?

0 Answers  

What is Phase od VPN in site to site and what information you will require to configure a SITE to SITE VPN

0 Answers   Infosys,

Which 2 commands shows the Cisco IOS filename? A.) show IOS B.) show ver C.) show flash D.) show mem E.) show NVRAM

1 Answers  

For more CCNA Interview Questions Click Here
Categories