Interested to Buy Any Domain ? << Click Here >> for more details...
Which command will display Ethernet 0's IP address?
A.) display ip address e0
B.) show ip interface e0
C.) show address e0
D.) sh ip address e0
E.) show all
- 1 Answers
- 4124 Views
- I also Faced
- E-Mail Answers
what is the purpose of multicast packets?
What do the following commands accomplish? access-list 1 deny 172.16.4.0 0.0.0.255 access-list 1 permit any interface ethernet 0 IP access-group 1 out A. This will block traffic from subnet 172.16.4.0 and allow all other traffic. B. This will allow traffic from subnet 172.16.4.0 and block all other traffic. C. All traffic is allowed. D. All traffic is blocked.
What is the protocol number for UDP? A.) 6 B.) 17 C.) 25 D.) 21
what is the default ad value of the interface directly coneted to router. as for exmaple ad value of ospf is 90 then from ehternet the network is conected whta is difault value of that directly conected interface. what is the defalt ad value of bgp whta is access llist and how many type of access list what is vlan what is vpn how e congigure the router what is mpls these are the question skrd to me at tcs i have replyed all ecxept the first one
wat is last assignable host address in 209.165.201.0/27 network?
Which layer is responsible for routing through an internetwork? A.) Physical B.) Session C.) Network D.) Transport E.) Application F.) Data Link
When using access lists, what does a Cisco router check first? A. To see if the packet is routable or bridgeable B. The destination address C. The source address D. The packet contents
There are 2 types of PPP authentication supported by the Cisco IOS. What are they? A.) PAP B.) PREDICTOR C.) MD5 D.) CHAP E.) STACKER F.) MSCHAP
Which statement about the flow control function of TCP is true? A. TCP makes no snarl to check for lost or duplicate data packets B. The application layer must sequence data packets when using TCP C. TCP controls the flow of UDP data through negative acknowledgements (NAK) D. TCP is a connection oriented protocol that acknowledges receipt of data packets and is considered reliable
Bridges work at what layer of the OSI model? A.) Data Link B.) Network C.) Physical D.) Application
12 Answers KVS, PGT,
What are the three sources of signal degradation on a data link?
Identify the default values that make up IGRP's composite metric? A.) Bandwidth B.) Load C.) Reliability D.) MTU E.) Delay
CCNA 
